Assa Abloy Securitron Vista V2M1200 Series User manual

501-10005
V2M1200/1290 SERIES SINGLE DRILL TEMPLATE
Securitron
Phoenix, AZ 85044
Tel: [phone]
Mon-Fri: 6:00am - 4:00pm PDT
Fax: [phone]
www.securitron.com

501-10005
MOUNTING INSTRUCTIONS
STEP 1
LOCATING MOUNTING HOLES
A. FOLD template at dotted line.
B. PLACE bottom portion of template
against the door.
C. LOCATE and MARK the three (3)
holes on the armature plate.
D. LOCATE and MARK the two (2)
adjustment header plate holes and
wire hole on the header mounting
plate.
STEP 2
INSTALLING ARMATURE PLATE
A. DRILL a level 1/4” diameter hole
through the door. FOLLOW with a
1/2” diameter drill.
NOTE: The following is for a solid door
only!
B. DRILL two (2) 1/4” holes for the anti-
rotation pins ¾” deep.
C. MOUNT the armature plate to the
door with the sex bolt.
D. PLACE a metal washer, a rubber
washer, and a metal washer on the
bolt between the door and the
armature.
E. ENSURE armature rocks on the door.
STEP 3
HEADER MOUNTING PLATE
A. MOUNT header plate to jamb
using the two (2) adjustment
holes.
B. RUN the control cable through the
wire hole.
C. SLIDE maglock on the header
mounting plate.
D. ADJUST the position of the
maglock to contact the armature.
E. REMOVE the maglock and
SECURE header mounting plate
with the eight (8) remaining
screws.
STEP 4
INSTALLING MAGNET
A. SLIDE maglock on the header
plate.
B. FASTEN maglock to header plate
with the Allen head cap screws
located at each end of the lock.
C. After checking for proper
operation and alignment, APPLY
THE screw locking agent to the
header mounting plate screws,
armature, andAllen head cap
screws.
Securitron is a brand associated with Hanchett Entry Systems, Inc., anASSA
ABLOY Group company. Copyright © 2016, Hanchett Entry Systems, Inc. All rights
reserved. Reproduction in whole or in part without the express written permission of
Hanchett Entry Systems, Inc. is prohibited.