Autel MaxiSys ADAS User manual

8pcs
Email: [email protected]
Web: www.autel.com
ASSEMBLY INSTRUCTION
Parts List
MaxiSys ADAS (Target Board Holder)
1pc
4pcs
1pc 1pc 1pc
1pc 1pc
Slide Bar
06022
Left Pole
060023
Hex L-wrench (5mm)
060028
Right Pole
060024
Connecting Bar
060025
Assemble the Target Board Holder
Place the left and right poles on a flat, level surface. Align the
screw holes on the connecting bar with those on the left and right
poles. Insert the bolts (M6x40) and tighten with the hex L-wrench
(5mm).
Insert the bolts (M4x8) into four screw holes on bar brackets and
tighten with the hex L-wrench (3mm). Ensure the connecting bar
is firmly attached to the left and right poles.
Hex L-wrench (3mm)
060029
12
Thank you for purchasing this Autel diagnostic tool. This tool, manufactured to a high standard will if used according to the
instructions and properly maintained give you years of trouble-free performance.
WARNING:
• Serious or fatal crushing injuries can occur from frame tip-over. To prevent the calibration frame from tipping over it must be
secured to the ground during the assembly.
• Improper assembly of the calibration frame may result in permanent damage to the frame and may render it inoperable and/or
unsafe.
Bolt (M4x8)
060027
Bolt (M6x40)
060026

Align the four screw holes on the slide bar with those on the left
and right poles. Insert bolts (M6x40) and tighten with the hex
L-wrench (5mm).
Insert the two poles into the slots on each side of the lifter of the
calibration frame. Tighten the hand knobs adjacent to the slots
and secure the target board holder to the lifter.
Use the locker on the slider to secure the target board to the slide
bar.
Attach the target board to the slide bar with two pins on the slider
inserted into the holes on the back of the target board.
3 4
5 6
7
Note: To move target board, turn hand knob counter-
clockwise to loosen board, slide it to the appropriate
position on slide bar and secure target board by
turning knob.