AXIOMTEK eBOX670-883-FL Series User manual

©Copyright 2014Axiomtek Co., Ltd.
Version A1Aug 2014
Printed in Taiwan
9416K670000E
4
Installing the Hard Disk Drive – HDD/SSD-B
Step 1 Turn off the system and unplug the power-cord.
Step 2 Turn the system upside down, loosen screws of bottom.
Step 3 Please find the HDD bracket location then loosen screws of
HDD bracket to take out it.
Step 4 You can refer to below photo to find out four screw holes and
then set your HDD on bracket.
Step 5 Then turn the bracket upside down then fasten screws with
your 2.5” HDD/SSD. Connect SATA and Power cables.
Step 6 Finally, set the bracket into chassis then fasten screws to fix it
Note: Please be informed that you can get more detail information in
eBOX670-883 user’s manual.
eBOX670-883-FL Quick Installation Guide
©Copyright 2014Axiomtek Co., Ltd.
Version A1Aug 2014
Printed in Taiwan
9416K670000E
1
Packing List
System Unit x 1 DVD/CD x 1 (for Driver & Manual)
Quick Installation Guide x 1 Foot Pad x4
Screws Pack x 1 3 pin DCIN power connector
Optional SSD/HDD Optional Wall-mount Bracket
Optional mSATA Optional DRAM
Optional Mini Card Modules Optional Antenna
Do not try to apply power to the system if any damaged components.
Dimensions
eBOX670-883-FL Series Embedded System

©Copyright 2014Axiomtek Co., Ltd.
Version A1Aug 2014
Printed in Taiwan
9416K670000E
2
I/O Outlets
The following figures show you I/O outlets on front and rear panels of the
eBOX670-883-FL Series.
Front View
Rear View
©Copyright 2014Axiomtek Co., Ltd.
Version A1Aug 2014
Printed in Taiwan
9416K670000E
3
Installing the Hard Disk Drive – HDD/SSD-A
Step 1 Turn off the system, and unplug the power cord.
Step 2 Turn the system upside down to locate screws at the bottom,
loosen screws.
Step 3 Remove the bottom cover.
Step 4 Please find the HDD bracket location then loosen four screws
of HDD bracket to take out it.
Step 5 Get brackets then fasten total four screws between two sides
of HDD/SSD. Please note the direction of HDD.
Step 6 Lock the HDD and fasten screws then connect SATA & Power
cables.
Step 7 Please fasten screws of HDD bracket to complete installation.