AXIOMTEK eBOX635-881-FL User manual

4 9416K635000E
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 May 2014
Printed in Taiwan
Step 3 Locate the memory module, insert the gold colored contact
into the socket, and push the module down, until it is firmly
seated by locking two latches on the sides.
Step 4 Take 2nd thermal pad, remove the transparent plastic Mylar
and stick it onto memory.
Step 5 Assembly the memory bracket , fasten all screws of HDD
bracket and bottom cover to complete installation.
Installing the CF Card
Step 1 Turn off the system, and unplug the power cable.
Step 2 Turn the system to the side with CFast cover, and loosen
screws to remove the CFast cover.
Step 3 Slide CFast card into CFast slot with caution.
Step 4 Make sure the CFast is well installation
Step 5 Close the cover to the chassis, and fasten all screws.
eBOX635-881-FL Quick Installation Guide
9416K635000E 1
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 May 2014
Printed in Taiwan
Checklist
eBOX635-881-FL System
Unit x 1 CD x 1 (for Driver & Manual)
Quick Installation Guide x
1 2.5” SATA Mylar x 1
Screws Pack x 1 DRAM, CPU & PCH Thermal
pad
Optional Wall-mount kit Optional DDR3 SODIMM
Optional Antenna Optional Mini Card module
Optional 2.5” Storage Optional CFast™
Note: Please do not try to apply power to the system if any damaged
components.
Dimensions
eBOX635-881-FL Embedded System

2 9416K635000E
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 May 2014
Printed in Taiwan
I/O Outlets
The following figures show you I/O outlets on front and rear panels
of the eBOX635-881-FL.
Front View
Rear View
9416K635000E 3
©Copyright 2014 Axiomtek Co., Ltd.
Version A1 May 2014
Printed in Taiwan
Installing the HDD & Memory Module
<For HDD Disk Installation Section>
Step 1 Turn off the system, and unplug the power cable.
Step 2 Turn the system upside down to locate screws at the
Bottom, loosen screws. Remove the bottom cover and then
loosen four screws of 2.5” HDD drive bay.
Step 3 Assembly the HDD bracket together with the 2.5” SATA
device, fasten it with four screws.
Step 4 Connect SATA power and signal cables then fasten screws
of HDD bracket.
Step 5 Fasten the bottom cover of screws to complete installation.
< Memory Module Installation Section>
Step 1 Refer to the following photo to loosen four screws to take
out the bracket directly.
Step 2 Remove transparent plastic Mylar from thermal pad, and
stick the thermal pad onto motherboard.