AXIOMTEK eBOX671-885-FL Series User manual

©Copyright 2017 Axiomtek Co., Ltd.
Version A2 June 2017
Printed in T iw n
9416K671010E
4
Installing the SO-DIMM
Step 1 Turn off the system and unplug the power-cord.
Step 2 There are four screws on the top heatsink are used to
fasten the heatsink to the chassis.
Step 3 Loosen these screws to remove the top heatsink then
you can find dual SO-DIMM sockets on main board.
Step 4 Locate the memory module, insert the gold colored
contact into the socket, and push the module down,
until it is firmly seated by locking two latches on the
sides.
Step 5 Assemble top heatsink with chassis through 4 screws
carefully to complete SO-DIMM installation.
Note: Please be informed that you can get more detail information in
eBOX671-885 user’s manual.
eBOX671-885-FL Quick Installation Guide
©Copyright 2017 Axiomtek Co., Ltd.
Version A2 June 2017
Printed in T iw n
9416K671010E
1
Packing List
 System Unit x 1  DVD/CD x 1 ( Driver & Manual)

Quick Installation Guide x 1

Foot Pad x4
 Screws Pack x 1  Processor Thermal Pad
 3 Pin Phoenix Connector x 1  Remote Switch Cable x 1

Optional Wall-mount Bracket

Optional Antenna & Module
 Do not try to apply power to the system if any damaged components.
Dimensions
PoE Specification
Compliant:
- 4ports full-load, IEEE802.3af Class 2 (7Watt)
- 2ports full-load, IEEE802.3af Class 3 (15.4Watt)
- 1ports full-load, IEEE802.3at Class 4 (30Watt)
Power Output: Total maximum 30 watt for 4 ports
eBOX671-885-FL Series Em edded System

©Copyright 2017 Axiomtek Co., Ltd.
Version A2 June 2017
Printed in T iw n
9416K671010E
2
I/O Outlets
The following figures show you I/O outlets on front and rear panels of the
eBOX671-885-FL Series.
Front View
Rear View
© Copyright 2017 Axiomtek Co., Ltd.
Version A2 June 2017
Printed in T iw n
9416K671010E
3
Installing the CPU processor
Step 1 There are four screws on the top heatsink.
Step 2 Loosen these screws to remove the top heatsink.
Step 3 Disengage load lever by releasing down and out on the hook.
Step 4 Locate connection 1 indicator on the processor which
aligns with connection 1 indicator chamfer on the
socket.
Step 5 Place the processor into the socket body vertically
then follow the below photos to set thermal pad.
Step 6 Fasten four screws to assemble top heatsink with main
chassis to finish installation.