AXIOMTEK eBOX625-312-FL User manual

©Copyright 2019Axiomtek Co., Ltd.
Version A1 Jan 2019
Printed in Taiwan
9416K625030E
4
Installing of the Memory Module
Step 1 Turn off the system, and unplug the power cord.
Step 2 Turn the system upside down to locate screws at the side of
the system, and then loosen two screws and four foot pads.
Step 3 Remove both of the bottom cover.
Step 4 Locate the DDR3L SO-DIMM slot, holding the DDR3L SO-DIMM
at a 30 degree angle up from horizontal; slowly insert the
golden fingers into the DDR3L SO-DIMM slot until it is fully
inserted in.
Step 5 Press it down gently, until it is firmly seated by locking two
latches on the sides and place the thermal pad on the DRAM.
Step 6 Put the bottom cover back and fasten all screws.
Note: Please be informed that you can get more detail information
in eBOX625-312-FL user’s manual.
eBOX625-312-FL Quick Installation Guide
©Copyright 2019Axiomtek Co., Ltd.
VersionA1 Jan 2019
Printed in Taiwan
9416K625030E
1
Packing List
System Unit x 1 DRAM Thermal Pad x 1
Quick Installation Guide x 1 HDMI Cable Locking Clip (Optional)
DVD/CD x 1 12V/60W power adapter (Optional)
Screws Pack x 1 Power cord (Optional)
Pre-installed Foot Pad x 4
 Do not try to apply power to the system if any damaged components.
Dimensions
eBOX625-312-FL Series Em edded System

©Copyright 2019Axiomtek Co., Ltd.
Version A1 Jan 2019
Printed in Taiwan
9416K625030E
2
I/O Outlets
The following figures show you I/O outlets on front and rear panels of the
eBOX625-312-FL Series.
Front View
Rear View
©Copyright 2019Axiomtek Co., Ltd.
VersionA1 Jan 2019
Printed in Taiwan
9416K625030E
3
Installing of the 2.5" SATA Device
Step 1 Turn off the system, and unplug the power cord.
Step 2 Turn the system upside down to locate screws at the side of
the system, and then loosen two screws and four foot pads.
Step 3 Remove the bottom cover.
Step 4 Please prepare HDD/SSD and four M3*4L screws and then
assembly the HDD/SSD with the bracket.
Step 5 Connect the power and SATA cable directly and then make
sure the insertion is complete.
Note: Please notice the direction of connector for HDD/SSD.
Step 6 Put the bottom cover back and fasten all screws.