AXIOMTEK eBOX671-521-FL Series User manual

©Copyright 2019 Axiomtek Co., Ltd.
Version A1 May 2019
Printed in Tai an
9416K671020E
4
Installation of SO-DIMM Memory
Step 1 Turn off the system, and unplug the power adaptor.
Step 2 Loosen four screws on the top heatsink are used to fasten the
heatsink to the chassis.
Step 3 Located the dual SO-DIMM sockets on main board.
Step 4 Locate the memory module, insert a gold colored contact into
the socket and push the module two end latches till locked.
Step 5 Put the top cover back and fasten four screws back onto the
system.
Note: Please refer to the user’s manual to get more detail information.
eBOX671-521-FL Quick Installation Guide
©Copyright 2019 Axiomtek Co., Ltd.
Version A1 May 2019
Printed in Tai an
9416K671020E
1
Packing List
System Unit x 1 Terminal Block x 1
Quick Installation Guide x 1 Remote switch cable x 1
DVD/CD x 1 (for Driver & Manual) Foot Pad x 4
Thermal Grease x 1 Screw Pack x 1
 Do not try to apply power to the system if any damaged components.
Dimensions
eBOX671-521-FL Series Em edded System

©Copyright 2019 Axiomtek Co., Ltd.
Version A1 May 2019
Printed in Tai an
9416K671020E
2
I/O Outlets
The following figures show I/O outlets on the eBOX671-521-FL.
Front View
Rear View
1 1 x Reset button 7 1 x AT/ATX quick switch
2 1 x Power button 8 System LEDs
3 2 x Swappable HDD tray 9 1 x Remote power switch
4 1 x HDMI 1.4 10 1 x DisplayPort 1.2
5 4 x Antenna opening 11 2 x GbE
6 2 x USB 3.1 (Gen1) 12 4 x PoE
13 4 x USB 3.1 (Gen2) 17 24VDC power input
14 2 x DisplayPort via MXM 18 COM2 (RS232/422/485)
15 1 x DVI-I 19 COM1 (RS232/422/485)
16 Flexible I/O Window
© Copyright 2019 Axiomtek Co., Ltd.
Version A1 May 2019
Printed in Tai an
9416K671020E
3
Installation of Hard Disk Drive
Step 1 Turn off the system, and unplug the power adaptor.
Step 2 Loosen two of the SATA drive tray’s screws and extract the
SATA HDD drive bay.
Step 3 Turn the SATA drive tray upside down to install SSD/HDD and
then fasten the four HDD screws to secure the SATAdrive tray.
Step 4 Slide the SATA drive tray back into the system and fasten the
screws firmly to complete the installation.