AXIOMTEK GOT318W-521-PCT User manual

GOT318W-521-PCT
All-in-One
18.5” FHD TFT Fanless
PCT Multi-Touch Panel PC
User’s Manual

ii
Disclaimers
This manual has been carefully checked and believed to contain accurate information. Axiomtek
Co., Ltd. assumes no responsibility for any infringements of patents or any third party’s rights,
or any liability arising from such uses.
Axiomtek does not warrant or assume any legal liability or responsibility for the accuracy,
completeness or usefulness of any information in this document. Axiomtek does not make any
commitment to update any information in this manual.
Axiomtek reserves the right to change or revise this document and/or product at any time
without notice.
No part of this document may be reproduced, stored in a retrieval system, or transmitted in any
forms or by any means, electronic, mechanical, photocopying, recording, among others, without
prior written permission from Axiomtek Co., Ltd.
WARNING
•Replacing the battery with an incorrect model may cause an
explosion. Only use the same or equivalent type of battery as
recommended by the manufacturer.
•Properly dispose of used batteries according to the instructions.
©Copyright 2022 Axiomtek Co., Ltd.
All Rights Reserved
January 2022, Version A2
Printed in Taiwan

iii
Safety Precautions
Before getting started, please read the following important safety precautions.
1. Be sure to ground yourself to prevent static charge when installing any internal
components. Use a grounding wrist strap and place all electronic components in any
static-shielded devices. Most electronic components are sensitive to static electrical
charge.
2. Disconnect the power cord from the GOT318W-521-PCT prior to any installation. Be sure
both the system and all external devices are turned off. Sudden surge of power could ruin
sensitive components. Make sure the GOT318W-521-PCT series is properly grounded.
3. Make sure the voltage of the power source is correct before connecting the GOT318W-
521-PCT to any power outlet.
4. Turn off system power before cleaning. Clean the system using a cloth only. Do not spray
any liquid cleaner directly onto the screen.
5. Do not open the system’s back cover. If opening the cover for maintenance is a must, only
a trained technician is allowed to do so. Integrated circuits on computer boards are
sensitive to static electricity. To avoid damaging chips from electrostatic discharge,
observe the following precautions:
Before handling a board or integrated circuit, touch an unpainted portion of the
system unit chassis for a few seconds. This will help to discharge any static electricity
on human body.
When handling boards and components, wear a grounding wrist strap available from
most electronic component stores.
Trademark Acknowledgments
Axiomtek is a trademark of Axiomtek Co., Ltd.
Intel® and Pentium® are registered trademarks of Intel Corporation.
Windows 10 and Windows 10 IoT Enterprise are trademarks of Microsoft Corporation.
Other brand names and trademarks are the properties and registered brands of their respective
owners.

iv
Table of Contents
Disclaimers.....................................................................................................ii
Safety Precautions................................................................................iii
SECTION 1 INTRODUCTION ................................ 1
1.1...................................................................................General Descriptions
1
1.2................................................................................................Specifications
2
1.3...........................................................................Dimensions and Outlines
4
1.4.......................................................................................................I/O Outlets
6
1.5................................................................................................... Packing List
7
SECTION 2 ............................HARDWARE INSTALLATION
9
2.1......................................................................................... Open Back Cover
9
2.2.............................................................. Jumper and Connector Settings
10
2.2.1 Restore BIOS Optimal Defaults Jumper (JP4).......................................... 10
2.2.2 Auto Power On Jumper (JP6) ....................................................................11
2.2.3 COM Port Connector..................................................................................11
2.3......................................................................................Ethernet Connector
12
2.4............................................................................... Mounting the Panel PC
13
2.4.1 Panel Mount .............................................................................................. 13
2.4.2 Wall Mount................................................................................................. 15
2.4.3 VESA Arm Mount....................................................................................... 17
2.2.4 Desktop Mount .......................................................................................... 18
2.5.................................................................................. Hardware Installation
19
2.5.1 Installing an HDD ...................................................................................... 19
2.5.2 Installing DRAM......................................................................................... 20
2.5.3 Installing a CPU......................................................................................... 23
2.5.4 Connecting the Power Input...................................................................... 25

v
SECTION 3 ................................ AMI BIOS SETUP UTILITY
26
3.1............................................................................................................Starting
26
3.2............................................................................................Navigation Keys
26
3.3...................................................................................................... Main Menu
27
3.4............................................................................................ Advanced Menu
28
3.4.1 IT8625 Super IO Configuration ................................................................. 29
3.4.2 Hardware Monitor...................................................................................... 31
3.4.3 Trusted Computing.................................................................................... 32
3.4.4 ACPI Setting.............................................................................................. 34
3.4.5 CPU Configuration .................................................................................... 35
3.4.6 SATA Configuration ................................................................................... 36
3.4.7 PCH-FW Configuration ............................................................................. 37
3.4.8 USB Configuration..................................................................................... 38
3.5.................................................................................................Chipset Menu
38
3.5.1 System Agent (SA) Configuration ............................................................. 38
3.6............................................................................................... Security Menu
43
3.7...................................................................................................... Boot Menu
44
3.8......................................................................................... Save & Exit Menu
46
SECTION 4 DRIVER and INSTALLATION ............. 48
4.1.........................................................................................Operating System
48
4.1.1 Driver CD Content ..................................................................................... 48
4.2.................................................................................................Touch Screen
49
APPENDIX A WATCHDOG TIMER ......................... 50
A.1 .............................................................................. About Watchdog Timer
50
A.2 .......................................................................................... Sample Program
50
APPENDIX B iAMT SETTINGS.............................. 52

vi
B.1 ............................................................................................. Entering MEBx
52
B.2 ........................................................................Set and Change Password
52
B.3 ............................................................................................... iAMT Settings
54
B.4 ...................................................................................iAMT Web Console
............................................................................................................57

vii
This page is intentionally left blank.

GOT318W-521-PCT User’s Manual
Introduction 1
SECTION 1
INTRODUCTION
This section contains general information and detailed specifications of the GOT318W-521-
PCT, including the following subsections:
Figure 1-1 Front panel of the GOT318W-521-PCT
⚫General Descriptions
⚫Specifications
⚫Dimensions and Outlines
⚫I/O Outlets
⚫Packing List
1.1 General Descriptions
The GOT318W-521-PCT multi-touch panel PC adopts a 18.5-inch FHDTFT LCD with 500nit
brightness and supports the LGA1151 socket 8/9th gen Intel® Core™ i7/i5,i3 & Pentium®
processor (Tj 100°C) up to 35W, providing excellent computing performance and thermal
resistance. This fanless platform is particularly designed for operation under harsh
environments including steel refineries, oil pipes, ships, machine makers, and many more.
Having the abilities described below surely makes GOT318W-521-PCT the most robust and
cost-effective solution.
Designed for extended operating temperature range and ingress protection
The GOT318W-521-PCT’s compact industrial design and fanless cooling system allow the
panel PC to sustain an extended operating temperature range between 0°C and +50°C, making
the system a power-efficient solution. It also features an IP65 front bezel for protection from
liquid and dust.
Reliable and stable design
The GOT318W-521-PCT is specifically designed for vibration-prone environments, best for the
industrial machinery markets. With a patented anti-vibration design, the GOT318W-521-PCT is
able to work in operation mode under 1.0G (10 ~ 500Hz), which has significantly improved
system reliability and sustainability.
NOTE
Heavy-vibration may sometimes cause the LCD screen to flash in white
color; however, it won’t affect the function of the product.

GOT318W-521-PCT User’s Manual
2Introduction
WLAN antenna supported (optional)
The GOT318W-521-PCT includes two Mini Card slots as an add-on option for connecting to a
wireless LAN card under 802.11 a/b/g/n protocols or with other 4G/GPRS applications. These
slots also come with three fixed rotational WLAN/WWAN antennas as optional components for
wireless network connection.
Multi-Touch PCAP touch with 3H surface hardness
The GOT318W-521-PCT comes with a user friendly multi-PCAP touchscreen display which
allows users to operate the panel PC with direct touch. The surface hardness of the touch glass
is up to 7H, providing excellent anti-scratch protection.
Other features
The GOT318W-521-PCT features one 260-pin DDR4-2666/2400 SO-DIMM socket to support
maximum system memory capacity of up to 32GB, along with one 2.5” wide temperature SATA
HDD/SSD for storage needs. It also provides a full set of I/O including RS-232/422/485, USB
2.0, USB 3.0, audio (line-out), HDMI, DP and VGA output, as well as Gigabit Ethernet. This slim
panel PC option supports panel mount, wall mount, VESA mount, and desktop stand mount to
offer more installation flexibility.
1.2 Specifications
Main CPU Board
⚫CPU
➢LGA1151 socket 8/9th gen Intel® Core™ i7/i5 /i3& Pentium® processor (Tj 100°C), up
to 35W
⚫System Memory
➢1 x DDR4 2666/2400MHz SO-DIMM slot
➢Maximum memory up to 32GB
⚫BIOS
➢AMI UEFI BIOS
I/O System
⚫Standard I/O
➢1 x COM (1 x RS-232/422/485)
➢2 x USB 2.0
➢2 x USB 3.0
➢1 x Switch for power on/off
➢1 x Remote switch for power on
➢1 x AT/ATX switch
➢1 x Grounding hole
➢1 x HDMI output
➢1 x DP output
➢1 x VGA output by 9-pin D-sub female
➢1 x Audio line out
⚫Ethernet
➢1 x 10/100/1000 Mbps Ethernet with Intel® i211-AT; supports Wake-on-LAN, PXE Boot
ROM
➢1 x 10/100/1000 Mbps Ethernet with Intel® i219-V (LM); supports Wake-on-LAN, PXE
Boot ROM