Installation and Technical Information
BEGA
Due to the dynamic nature of lighting products and the associated technologies, luminaire data on this sheet is subject to change at the discretion of BEGA North America. For the most current technical data, please refer to bega-us.com
BEGA 1000 Bega Way, Carpinteria, CA 93013 (805)684-0533 © copyright BEGA 2023
Overview:
LED Watts: 23.6W
System Watts: 28.0W
Controllability: 0-10V dimmable
Weight: 27.6 lbs.
Protection Class: IP65
Tools Required:
• 4mm hex head screwdriver
Pole top luminaire - asymmetric wide beam 77 911
Dimensions
A: 26-5/8
B: 46-1/4
C: 40-1/8
Maintenance:
Clean regularly with solvent-free cleaner
removing dirt and debris. Do not use high
pressure cleaners.
Replacement Parts
See label inside of xture for LED replacement
part number.
Consult factory for all other replacement
components.
Accessories
Please refer to the appropriate accessory installation
sheet for further instruction when applicable.
Updated: 01/20/23
77 911 1 of 2
Notice to Installer:
1. For pole top applications only.
2. Slip ts 3” OD poles or tenons only. Requires a minimum 4” length of straight dia.
pole/tenon for proper installation.
3. Pole top luminaire is provided with a 25’ wire bundle to route through the pole for
suppy wiring connections.
Installation: Luminaire
1. Route the luminaire wiring through the pole to the base and slip t the luminaire over
the top of the pole.
2. Aim luminaire in desired direction. Secure luminaire into place by tightening the (6)
4mm set screws on the pole tter evenly. Set screws must be tightened to 12Nm.
3. Make supply wiring connections in base of pole:
MAIN VOLTAGE SUPPLY WIRE TO BLACK LUMINAIRE WIRE
NEUTRAL (COMMON) SUPPLY WIRE TO WHITE LUMINAIRE WIRE
GREEN GROUND WIRE TO GREEN LUMINAIRE WIRE
0-10V Dimming (if applicable):
DIMMING CONTROL (+) TO POSITIVE LUMINAIRE DIM CONTROL WIRE
DIMMING CONTROL (-) TO NEGATIVE LUMINAIRE DIM CONTROL WIRE
