Belson Outdoors CBPB-6A1B-BK User manual

627 Amersale Drive
Naperville, IL 60563
Phone: [phone]
Fax: [phone]
[email protected]
Instructions Sheet
www.belson.com
Model # CBPB-6A1B-BK
A
E
F
G
HJ
B
C
D
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED
(2) LEGSA
B (2) SUPPORT POLES
F (22) M10X45 BOLTS
G (22) M10 WASHERS
H (4) SELF TAPPING SCREWS
C (4) BULL NOSE SLATS
D (5) SEAT SLATS
E (2) CENTER SUPPORT
J (4) EXPAND ANCHOR BOLTS
2018-07-11 – Page 1

www.belson.com
2018-07-11 – Page 2
7
8
9
10
11
12
13
6
5
14
15
16
17
18
19
20
21
22
C 1
D 1
D 2
C 2
C 3
D 3
D 4
D 5 C 4
A 1
A 1
E 2
E 1
B 1
B 2
1
2
4
3
3
4
1
2

Surface Mount Installation
Step 1
Choose your desired location for the bench, then use a marker, chalk, or pencil to outline the holes of
the flange onto the base material.
Step 2
Move bench and drill 4 x 3/8” diameter holes at 3.0” depth. Place anchors in holes.
Step 3
Remove nuts and washers and carefully set bench over the anchors through the holes of the
bench feet.
Step 4
Place washers and nuts on the anchors then tighten. Make sure to keep anchors fully recessed while
tightening until set, do not over-tighten.
www.belson.com
2018-07-11 – Page 3
Make sure to assemble the bench on a soft mat to prevent scratching of the product’s surface.
Assemble on a flat surface to ensure that the bench is level when completed.
DURING ASSEMBLY, DO NOT TIGHTEN BOLTS COMPLETELY.
Bench Assembly
Step 1
Starting with the Legs (A) and Support Poles (B) fasten together with M10X45 Bolts (F:1-4) and M10
Washers (G:1-4). Lightly tighten the Bolts on one end, on the opposite end (’loose’) fasten with only 2
or 3 rotations to allow give for the Slats to fit into place.
Step 2
Place Center Supports (E) on the Support Poles (B). Center Supports are best secured into place
after the Slats are fastened.
Step 3
Position Seat Slats (D) and Bull Nose Slats (C) as shown and fasten with M10X45 Bolts (F:5-22) and
M10 Washers (G:5-22). Lightly tighten the Bolts on the same end as in Step 1, on the opposite
(’loose’) end fasten with only 2 or 3 rotations.
Step 4
Fully tighten all Bolts, starting with the loose end followed by the lightly tightened end.
Step 5
Position the bench upside down to position each Center Support (E). Position each approximately 17”
in from the Legs (A), then secure into place at both the top and the front with Self-tapping Screws
(G:1-4).
*Note: to level the bench it may be necessary to loosen bolts, then square bench, and then re-tighten utilizing a diagonal pattern.