Belson Outdoors RS8WB-PC User manual

111 North River Road
North Aurora, IL 60542
Phone: [phone]
Fax: [phone]
[email protected]
Model # RS8WB-PC Instructions Sheet
www.belson.com
ELITE OUTDOOR PARK BENCH 8’

www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED.
FP - FASTENER PACK
( 1 ) - ONE FASTENER PACK
( 4 ) - FOUR BENCH ENDS
( 1 ) - ONE SEAT BENCH BOARD
( 1 ) - ONE BACK BENCH BOARD

www.belson.com
1 - 3” PHILLIPS DRIVE BIT
ALSO NEEDED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS:
32 - #12 X 3” FLAT HEAD PHILLIPS SCREWS
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED.

www.belson.com
STEP #1:
ON THE CARDBOARD THAT THE BENCH WAS SHIPPED IN, STAND THE SEAT BENCH BOARD ON EDGE
WITH THE PILOT HOLES CLOSER TO THE GROUND, ON A LEVEL SURFACE.
STEP #2:
PLACE IN POSITION ( 1 ) ONE BENCH END AS SHOWN IN DIAGRAM, BEING SURE TO ALIGN THE PILOT
HOLES TO THE PRE-DRILLED HOLES IN THE BENCH END. AFTER THE HOLES ARE PROPERLY ALIGNED,
FASTEN WITH ( 1 ) ONE #12 X 3” FLAT HEAD PHILLIPS SCREW PER HOLE.
NOTE: DO NOT TIGHTEN SCREW COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
#12 X 3” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #3:
REPEAT STEP #2 FOR THE REMAINING BENCH ENDS.
NOTE: BE SURE TO TIGHTEN ALL SCREWS COMPLETELY AFTER THIS STEP.
#12 X 3” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #4:
PLACE THE BENCH IN THE UP RIGHT POSITION. USE CARE, FOR THE BENCH WEIGHS APPROXIMATELY
150 POUNDS.
STEP #5:
PLACE THE BACK BENCH BOARD IN POSITION SHOWN IN DIAGRAM. USE ( 1 ) ONE #12 X 3” FLAT HEAD
PHILLIPS SCREW IN THE TOP HOLE OF THE LEFT BENCH END. REPEAT FOR THE RIGHT BENCH END.
NOTE: DO NOT TIGHTEN SCREWS COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
#12 X 3” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #6:
USING ( 1 ) ONE #12 X 3” FLAT HEAD PHILLIPS SCREW PER HOLE, FINISH FASTENING THE BACK
BENCH BOARD TO THE BENCH ENDS.
NOTE: BE SURE TO TIGHTEN ALL SCREWS COMPLETELY AFTER THIS STEP.
#12 X 3” FLAT HEAD
PHILLIPS SCREW