Belson Outdoors RB-CA User manual

Model # RB-CA Instructions Sheet
www.belson.com
RECYCLED PLASTIC BENCH OPTIONAL CENTER ARM
627 Amersale Drive
Naperville, IL 60563
Phone: [phone]
Fax: [phone]
[email protected]
STEP #1:
UNPACK AND LAY OUT PIECES IN THE KIT. VERIFY THAT THE PARTS, QUANTITY, AND COLOR MATCH
THOSE ON THE ENCLOSED BILL OF MATERIAL.
STEP #2:
BEGIN WITH THE ARM CASTING (100030-X_)AND SET IT UPRIGHT ON THE BENCH, NEAR
DESIRED LOCATION WITH THE LONG LENGTH FACING TOWARD THE BACK OF THE BENCH.
SEE DIAGRAM 1.
STEP #3:
INSERT THE “BACK”END OF THE ARM WITH ITS LUG BETWEEN THE BOTTOM AND NEXT LOWER
BOARDS ON THE BACK OF THE BENCH. SEE DIAGRAM 1
STEP #4:
MOVE THE ARM SO IT IS AT AN ANGLE TO THE BACK OF THE BENCH. PUSH DOWN ON THE ARM
TO SET THE “FRONT”LEG WITH THE LUG BETWEEN THE TWO OUTER BOARDS ON THE SEAT OF THE
BENCH. SEE DIAGRAM 1.
DIAGRAM 1: LOCATING ARM REST

www.belson.com
STEP #5:
STRAIGHTEN THE ARM SO IT IS PERPENDICULAR TO THE BACK OF THE BENCH. SLIDE THE ARM INTO
THE LOCATION DESIRED ON THE BENCH. (USUALLY THE ARM MOUNTS AT A CENTER POSITION BETWEEN
ENDS.) NOTE: ON AN EIGHT FOOT BENCH (400201), THE OPTIONAL ARM WILL MOUNT TO ONE SIDE OR THE
OTHER OF THE SUPPORT CASTING 100031-TO CENTER THE ARM FOR COMFORTABLE SEATING IT WILL BE
NECESSARY TO MOVE THE SUPPORT CASTING TO A DIFFERENT LOCATION.
STEP #6:
PLACE ONE ANCHOR PLATE 100083 AT BACK OF BENCH OPPOSITE LUG OF 100030 AND INSTALL TWO
TAMPER PROOF SCREWS (71-TP1420134BH) THROUGH TWO LOCK WASHERS (71-14LW-SS) INTO THE
THREADED HOLES OF THE SPACING LUG AT END OF ARM. SNUG THE SCREWS BUT DO NOT TIGHTEN
AT THIS TIME. SEE DIAGRAM 2.
STEP #7:
PLACE ONE ANCHOR PLATE 100083 UNDER SEAT OF BENCH OPPOSITE LUG OF 100030 AND INSTALL TWO
TAMPER PROOF SCREWS (71-TP1420134BH) THROUGH TWO LOCK WASHERS (71-14LW-SS) INTO THE
THREADED HOLES OF THE SPACING LUG AT END OF ARM. SNUG THE SCREWS BUT DO NOT TIGHTEN AT
THIS TIME. SEE DIAGRAM 2.
DIAGRAM 2: LOCATING ANCHOR PLATES

www.belson.com
STEP #8:
MAKE CERTAIN THE ARM IS ORIENTED VERTICALLY TO THE SEAT, PERPENDICULAR TO THE BACK OF
THE BENCH, AND IN LOCATION DESIRED. TIGHTEN THE FOUR SCREWS. NOTE: USE CARE WHEN
TIGHTENING SCREWS TO AVOID STRIPPING THE THREADS IN THE CAST ALUMINUM SPACING LUG.
SEE DIAGRAM 3.
DIAGRAM 3: ALIGNMENT, FRONTAL VIEW