Belson Outdoors T40-02 User manual

111 North River Road
North Aurora, IL 60542
Phone: [phone]
Fax: [phone]
[email protected]
Model # T40-02 Instructions Sheet
www.belson.com
40 GALLON TRASH RECEPTACLE

www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED.
FP - FASTENER PACK
( 1 ) - ONE FASTENER PACK
C - FLAT TOP
( 1 ) - FLAT TOP
B - FRAME KIT
( 1 ) - ONE FRAME RING
D - BAG HOLDER RING
( 1 ) - ONE BAG HOLDER RING
( 1 ) - ONE TRASH CAN LINER A - SIDE PANEL
( 4 ) - FOUR SIDE PANELS

www.belson.com
1 - 3” PHILLIPS DRIVE BIT
ALSO NEEDED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS:
16 - #12 X 2-1/2” FLAT HEAD PHILLIPS SCREWS
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED.

#12x 2-1/2” FLAT
HEAD PHILLIPS SCREW
www.belson.com
STEP #1:
LAY A SIDE PANEL AS SHOWN. PLACE THE BAG HOLDER RING AT THE TOP OF THE PANEL
AND THE FRAME RING AT THE BOTTOM OF THE PANEL, AS SHOWN IN THE ABOVE DIAGRAM.
SLIDE THE INNER PANEL INTO THE CENTER OF THE TWO RINGS AS SHOWN ABOVE, MAKING
SURE THE HOLES LINE UP WITH THE PRE-DRLLED PILOT HOLES IN THE PANEL. FASTEN USING
( 1 ) ONE 2-1/2” FLAT HEAD PHILLIPS SCREW PER HOLE.

www.belson.com
STEP #2: PLACE ANOTHER SIDE PANEL BESIDE THE PREVIOUS PANEL, SO THAT IT TOUCHES AS
DISPLAYED IN THE DIAGRAM ABOVE. GENTLY TURN THE SIDE PANEL WITH THE RINGS INSTALLED
ONTO THE NEW SIDE PANEL. SLIDE THE INNER PANEL INTO THE CENTER OF THE RINGS ABOVE,
MAKING SURE THE HOLES LINE UP WITH THE PRE-DRILLED PILOT HOLES IN THE PANEL. FASTEN
USING ONE #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW PER HOLE. REPEAT THIS STEP FOR THE REST
OF THE SIDE PANELS.
#12 X 2-1/2” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #3:
TURN THE TRASH RECEPTACLE UPRIGHT ONTO ITS BASE. PLEASE USE CAUTION WHILE MOVING,
AT THIS POINT IN ASSEMBLY, THE RECEPTACLE WILL WEIGH APPROXIMATELY 145 POUNDS. PLACE
THE TRASH LINER INSIDE THE BASE.

www.belson.com
STEP #4:
TO PLACE THE LID ON THE TRASH RECEPTACLE, REST IT ON THE INNER LEDGE OF THE SIDE WALLS.