Belson Outdoors PL6NB-P User manual

Model # PL6NB-P Instructions Sheet
www.belson.com
TRADITIONAL RECYCLED PLASTIC PLANK BENCHES
627 Amersale Drive
Naperville, IL 60563
Phone: [phone]
Fax: [phone]
[email protected]

www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED.
FP - FASTENER PACK
( 1 ) - ONE FASTENER PACK
C - BENCH END
( 3 ) - THREE BENCH ENDS
A - CENTER BENCH BOARD
( 1 ) - ONE CENTER BENCH BOARD
B - SIDE BENCH BOARD
( 2 ) - TWO SIDE BENCH BOARDS

www.belson.com
1 - 3” PHILLIPS DRIVE BIT
ALSO NEEDED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS:
18 - #12 X 2-1/2” FLAT HEAD PHILLIPS SCREWS
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED.

www.belson.com
STEP #1:
PLACE THE CENTER BENCH BOARD ON A LEVEL SURFACE WITH THE PILOT HOLES FACING UP.
ON EACH SIDE OF THE CENTER BENCH BOARD, PLACE ( 1 ) ONE SIDE BENCH BOARD WITH THE
PILOT HOLES CLOSEST TO THE CENTER BENCH BOARD AND FACING UP.
STEP #2:
PLACE ( 1 ) ONE BENCH END IN POSITION, AS SHOWN ABOVE, BEING SURE TO ALIGN THE PRE-
DRILLED HOLES TO THE PILOT HOLES IN THE BENCH BOARDS. AFTER THE HOLES ARE PROPERLY
ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW PER HOLE TO SECURE.
NOTE: DO NOT TIGHTEN SCREW COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
#12 X 2-1/2” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #3:
PLACE THE LAST ( 2 ) TWO BENCH END IN POSITION, AS SHOWN ABOVE, BEING SRE TO ALIGN THE
PRE-DRILLED HOLES TO THE PILOT HOLES IN THE BENCH BOARDS. AFTER THE HOLES ARE
PROPERLY ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW PER HOLE
TO SECURE.
NOTE: BE SURE TO TIGHTEN ALL SCREWS COMPLTELY AFTER THIS STEP.
#12 x 2-1/2” FLAT HEAD
PHILLIPS SCREW