Belson Outdoors DF6SH-P User manual

Model # DF6SH-P Instructions Sheet
www.belson.com
RECYCLED PLASTIC HEXAGONAL
PLAZA PICNIC TABLE
UNIVERSAL ACCESS
627 Amersale Drive
Naperville, IL 60563
Phone: [phone]
Fax: [phone]
[email protected]

R - TABLE CENTER
( 2 ) - TWO TABLE CENTERS
Y - HA SEAT SUPPORT
( 2 ) - TWO HA SEAT SUPPORTS
Q - SEAT SUPPORT
( 1 ) - ONE SEAT SUPPORT
www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED.
W - LEFT LONG SEAT
( 1 ) - ONE LEFT LONG SEAT
U - RIGHT LONG SEAT
( 1 ) - ONE RIGHT LONG SEAT
N - LEFT SHORT SEAT
( 1 ) - ONE LEFT SHORT SEAT
O - RIGHT SHORT SEAT
( 1 ) - ONE RIGHT SHORT SEAT
H - TABLE LEG
( 3 ) - THREE TABLE LEGS
J - TABLE TOP
( 1 ) - ONE TABLE TOP
FP - FASTENER PACK
( 1 ) - ONE FASTENER PACK

www.belson.com
1 - 3” PHILLIPS DRIVE BIT
ALSO NEEDED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS:
6 - 3/8” X 4-1/4” HEX HEAD BOLT
12 - 3/8” FLAT WASHER
6 - 3/8” NYLON LOCK NUT
6 - #12 X 3” FLAT HEAD PHILLIPS SCREW
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED.

www.belson.com
STEP #1:
PLACE THE CENTER BENCH BOARD ON A LEVEL SURFACE WITH THE PILOT HOLES FACING UP.
ON EACH SIDE OF THE CENTER BENCH BOARD, PLACE ( 1 ) ONE SIDE BENCH BOARD WITH THE
PILOT HOLES CLOSEST TO THE CENTER BENCH BOARD AND FACING UP.
STEP #2:
PLACE ( 1 ) OBE BENCH END IN POSITION, AS SHOWN ABOVE, BEING SURE TO ALIGN THE PRE-
DRILLED HOLES TO THE PILOT HOLES IN THE BENCH BOARDS. AFTER THE HOLES ARE PROPERLY
ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW PER HOLE TO SECURE.
NOTE: DO NOT TIGHTEN SCREW COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
#12 X 2-1/2” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #3:
PLACE THE LAST ( 2 ) TWO BENCH END IN POSITION, AS SHOWN ABOVE, BEING SRE TO ALIGN THE
PRE-DRILLED HOLES TO THE PILOT HOLES IN THE BENCH BOARDS. AFTER THE HOLES ARE
PROPERLY ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW PER HOLE
TO SECURE.
NOTE: BE SURE TO TIGHTEN ALL SCREWS COMPLTELY AFTER THIS STEP.
#12 x 2-1/2” FLAT HEAD
PHILLIPS SCREW