Belson Outdoors CAMBRIDGE CA8NB-P User manual

111 North River Road
North Aurora, IL 60542
Phone: [phone]
Fax: [phone]
[email protected]
Model # CA8NB-P Instructions Sheet
www.belson.com
CAMBRIDGE RECYCLED PLASTIC MEMORIAL PARK BENCH

www.belson.com
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL COMPONENTS ARE INCLUDED.
FP - FASTENER PACK
( 1 ) - ONE FASTENER PACK
A - CENTER BENCH BOARD
( 4 ) - FOUR CENTER BENCH BOARDS
B - BULL NOSED BENCH BOARD
( 2 ) - TWO BULL NOSED BENCH BOARDS
C - BENCH END
( 4 ) - FOUR BENCH ENDS

www.belson.com
1 - 3” PHILLIPS DRIVE BIT
ALSO NEEDED FOR THIS ASSEMBLY WILL BE THE FOLLOWING MATERIALS:
48 - #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW
BEFORE ASSEMBLY, PLEASE MAKE SURE ALL FASTENERS ARE INCLUDED.

www.belson.com
STEP #1:
PLACE THE CENTER BENCH BOARDS ON A LEVEL SURFACE WITH THE PILOT HOLES FACING UP.
ON EACH SIDE OF THE CENTER BENCH BOARDS, PLACE ( 1 ) ONE SIDE BENCH BOARD WITH
THE PILOT HOLES CLOSEST TO THE CENTER BENCH BOARDS AND FACING UP.
STEP #2:
PLACE ( 1 ) ONE BENCH END IN POSITION, AS SHOWN ABOVE, BEING SURE TO ALIGN THE PRE-
DRILLED HOLES TO THE PILOT HOLES IN THE BENCH BOARDS. AFTER THE HOLES ARE PROPERLY
ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW PER HOLE TO SECURE.
NOTE: DO NOT TIGHTEN SCREW COMPLETELY. THIS WILL BE DONE IN A LATER STEP.
#12 X 2-1/2” FLAT HEAD
PHILLIPS SCREW

www.belson.com
STEP #3:
PLACE THE REMAINING BENCH ENDS IN POSITION, AS SHOWN ABOVE, BEING SURE TO ALIGN
THE PRE-DRILLED HOLES TO THE PILOT HOLES IN THE BENCH BOARDS. AFTER THE HOLES
ARE PROPERLY ALIGNED, FASTEN WITH ( 1 ) ONE #12 X 2-1/2” FLAT HEAD PHILLIPS SCREW
PER HOLE TO SECURE.
NOTE: BE SURE TO TIGHTEN ALL SCREWS COMPLETELY AFTER THIS STEP.
#12 X 1-1/2” FLAT
HEAD PHILLIPS SCREW