MMX 200 wireless 3
1. Introduction
In accordance with the Electrical and Electronic
Equipment Act (ElektroG) and the European WEEE
Directive 2012/19/EU, electrical and electronic
equipment mu be disposed of separately from
household wae at the end of their life.
If the device is operated with batteries
, these mu be
removed from the device before disposal. If batteries
are permanently inalled in the device, they mu be
removed by professional a for safety reasons.
These disassembly inructions show how to proceed.
2. Information for Germany on disposal
in accordance with the Electrical and
Electronic Equipment Act (ElektroG)
and the WEEE Directive 2012/19/EU
uThe symbol of the crossed-out dubin
on the product, in the operating
inructions or on the packaging means
that electrical and electronic devices
mu be disposed of separately from
household wae at the end of their life
cycle.
uAlways dispose of used equipment in
accordance with applicable regulations.
uFor the return of old equipment,
batteries and
rechargeable batteries,
there are free collection
points or a free
return to beyerdynamic, as well as other
acceptance points for reuse. The
addresses are available at the local city
or municipal adminiration.
uDealers for electronic equipment are
generally obliged to take back wae
electrical/electronic equipment free of
charge. This obligation also applies to
sales via remote communication.
uFor fuher information, please contact
the local authorities or the dealer from
whom the product was purchased.
uThe consumer/end-user is responsible
for the deletion of personal data on the
wae electrical/electronic equipment.
3. Disposal of batteries
uDispose of batteries separately aer use
from the product in accordance with
applicable regulations. They mu not
be disposed of in household wae. The
return is free of charge for consumers/
end users.
uBefore disposal, discharge and remove
the batteries.
4. Removing the battery
uCaution:
Before removal discharge the battery.
For this product a non-deructive
removal of the battery by the end user
is not possible. Due to the safety risk,
this activity may only be carried out by
professional a.
Please contact beyerdynamic or consult
independent professional a.
uCarefully remove the
bale.
Attention: The cable
of the circuit board is
soldered to the bale.
uDischarge battery
before disposal.
uTo make it easier to
remove the battery,
remove the ear pads on
both sides by turning
them anti-clockwise.
uLoosen the three screws
of the bale on the
right-hand side of the
headphones using a
suitable screwdriver.
