Bissell CrossWave Cordless 2551 Series User manual

CROSSWAVE® CORDLESS
BATTERY REMOVAL INSTRUCTIONS
2551 SERIES

1. Turn power OFF. Use a
Phillips-head screwdriver to
remove the six screws on the
back of the machine. Then, lift
off the back cover.
2. Use rubber-handled wire
cutters to cut the yellow
positive (+) wire and wrap
the end of the yellow cut wire
with electrical tape. Then, cut
the black wire and wrap it
with electrical tape. DO NOT
CUT THE TWO WIRES AT THE
SAME TIME. Then, disconnect
the battery wire connector
and wrap the connector with
electrical tape.
3. Use a Phillips-head
screwdriver to remove the
four screws on the sides of the
battery pack. Then, remove
the battery pack from the
machine. Keep battery pack
together – DO NOT separate
individual batteries.
Disposing of the Battery
Before disposing the battery, make sure:
• The machine is disconnected from the 3-in-1 Docking Station.
• The Clean and Dirty Water Tanks are empty or removed from the machine.
• A Phillips-head screwdriver, electrical tape and rubber handled wire cutters are available
for disassembly.
©2020 BISSELL Inc. All rights reserved.
Part Number 1625158 07/20
WARNING This product contains Lithium-Ion rechargeable batteries. DO NOT mix Lithium-Ion
batteries with general household waste. According to Federal and State regulations, removal and proper disposal
of Lithium-Ion batteries is required. For specific battery disposal instructions please contact Call2Recycle at
877-723-1297 or visit www.call2recycle.org.
NOTICE Disconnecting the battery will destroy the appliance and invalidate the warranty.