Bissell SPINWAVE 2315 Series User manual

SPINWAVE® CORDLESS
BATTERY REMOVAL INSTRUCTIONS
2315, 2307 SERIES

1. Use a screwdriver to
unscrew the screw on the back
of the machine just below the
carry handle. When the screw
is removed, lift the handle off
while pressing the driver in
and up.
Note: Cable will remain
connected to handle.
2. With a Phillips-head
screwdriver, remove the 5
screws on the back of the
machine.
3. Insert a flathead screwdriver
between the top front and
back plates between the Carry
Handle and main handle. Then
pry housings apart to release
eleven locking tabs along
perimeter.
4. Remove the control
panel with battery pack. For
leverage, you may need to use
the flathead screwdriver.
5. Disconnect the 8 inputs
that are connected to the
control panel.
6. Pull the control panel back
from the battery pack. Place
battery in a sealable bag and
follow the instructions for
disposal in the note below.
Disposing of the Battery
Before disposing the battery, make sure:
• The machine is disconnected from the charger.
• The Clean Water Tank has been removed from the machine.
• A Phillips-head screwdriver and rubber handled wire cutters are available for disassembly.
©2020 BISSELL Inc. All rights reserved.
Part Number 1625068 06/20 RevA
WARNING This product contains Lithium-Ion rechargeable batteries. DO NOT mix Lithium-Ion
batteries with general household waste. According to Federal and State regulations, removal and proper disposal
of Lithium-Ion batteries is required. For specific battery disposal instructions please contact Call2Recycle at
877-723-1297 or visit www.call2recycle.org.
NOTICE Disconnecting the battery will destroy the appliance and invalidate the warranty.