Blaupunkt IVMR 1042P User manual

1

2
TABLE OF CONTENTS
Monitor overview . . . . . . . . . . . . . . 3
IR remote control overview . . . . . . . 5
Notes for the user . . . . . . . . . . . . 6
Precautionary measures . . . . . . . . . 6
Safety notices . . . . . . . . . . . . . 6
Supplied parts . . . . . . . . . . . . . . 7
Installing the monitor . . . . . . . . . 8
Installing the monitor (mechanical) . . 8
Cables . . . . . . . . . . . . . . . . . . . . . . 9
Operation . . . . . . . . . . . . . . . . . 10
Controlling the interior lighting
(monitor) . . . . . . . . . . . . . . . . . . . 10
Opening the monitor . . . . . . . . . . . 10
Adjusting the position of the
monitor . . . . . . . . . . . . . . . . . . . . 11
Closing the monitor . . . . . . . . . . . 11
Powering on the monitor . . . . . . . . 11
OSD menu . . . . . . . . . . . . . . . . . . 12
IR headphones IVHS-01
(accessory) . . . . . . . . . . . . . . . . . 12
Changing the light bulb . . . . . . . . . 13
Changing the battery in the
remote control . . . . . . . . . . . . . . . 13
Specifications . . . . . . . . . . . . . . 14
IVMR-7002P . . . . . . . . . . . . . . . . 14
IVMR-1042P . . . . . . . . . . . . . . . . 14
English

3
MONITOR OVERVIEW (IVMR-7002P Shown)
1 2 3 4
5
10
7
6 8
9
111
13
14
12
*Note: Buttons 6-9 are located on
the right side of the display screen
on Model IVMR-1042P.
*

Lights on the main unit
Light switch ON
Monitor latch
Vehicle interior lighting switch
Infrared receiver for IR remote
control IVRC-06
Infrared transmitter for IR
headphones IVHS-01 (accessory)
Control button
Navigate in the OSD menu
Control button
Navigate in the OSD menu
Control button MENU
See Instructions / OSD menu
On/off button for the monitor
LCD screen
Extension cable (13 pin)
Adapter cable RCA/jack (13 pin)
Red wire = +12V Ignition
Black wire = Ground
Red RCA plug = Audio In (R)
White RCA plug = Audio In (L)
Yellow RCA plug = Video In
Blue phono plug = IR pass through
for Blaupunkt DVD
players (DVD-
ME2, DVD-ME3 &
DVD-ME R).
Cable for the interior lighting
(3 wires)
Red wire = Constant +12V
White wire = To the door switch
(Negative Door
Trigger)
Black wire = Ground
AUX Input (use for games)*
Red RCA = Audio IN (R)
White RCA = Audio IN (L)
Yellow RCA = Video IN
*Note: Press TV/Video button on
the remote to switch between AV1
and AUX.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
4
MONITOR OVERVIEW
English
11

POWER
On/off button for the monitor.
TV/VIDEO
Input selector: switch between
AV1 and AUX.
VOL arrow button /
(Not used)
MUTE
CH arrow button /
(Not used)
MENU
See Instructions / OSD menu
Battery compartment
15
16
17
18
19
20
21
5
IR REMOTE CONTROL OVERVIEW
15 16 17 18
19
20
21

6
NOTES FOR THE USER
Thank you for choosing a Blaupunkt
product. We hope you enjoy using this
new piece of equipment. Please read
these operating instructions before
using the equipment for the first
time.
Precautionary measures
Please observe all the warning
notices, precautionary measures and
maintenance tips contained in these
operating instructions so as to extend
the life of your monitor.
Warning
Video products should never be in
view of the driver. Operation of Video
within view of the driver is illegal.
• Do not place the monitor in the
following positions:
1. Positions in which it could restrict
the driver’s view.
2. Positions in which it could
become a danger to safety (e.g.
hand brake, steering wheel,
gearshift lever and airbag).
• Only operate the device with the
recommended voltage supply of
12 V direct current.
• Do not attempt to open or dismantle
the monitor, since you could suffer
an electric shock as a result.
• Avoid using the monitor in
environments where it is subjected
to dust, dirt or moisture.
• Do not install the monitor in places
where it is subjected to direct
sunlight.
Blaupunkt recommends having all your
video products installed by an
authorized dealer.
Safety notices
Please observe the following safety
notices during installation and while
making the connections.
- Disconnect the negative and positive
terminals of the battery.
- When doing so, please observe the
safety notices provided by the
vehicle manufacturer.
- Before drilling the holes necessary
for mounting the equipment and for
laying cables, please make sure that
concealed cables, the fuel tank and
fuel lines cannot be damaged in the
process!
English

7
SUPPLIED PARTS
The monitor is supplied with all the
parts listed below. Please check that
the range of parts supplied with your
device is complete. If one of the listed
parts is missing, please contact your
dealer immediately.
• Monitor (including mounting plate
and screws)
• Remote control IVRC-06 with
battery
• 5 m long, 13-pin extension cable
• Connection adapter
(13-pin RCA/jack)
• Operating instructions

8
INSTALLING THE MONITOR
Installing the monitor
(mechanical)
Select a suitable position for secure
installation of the monitor:
• The device must not distract the
driver or restrict the driver’s view.
• The ability to enter and get out of the
vehicle must not be impeded.
• The device must not be installed in
such a way that could prevent the
other vehicle components from
functioning properly (e.g. sliding
sunroof).
• Make sure that the device is installed
in a safe and secure position and
that it cannot become detached in
the event of an emergency stop.
• Do not attach the device merely to
the roof liner.
• If you need to drill additional holes,
make sure you do not drill through
the sheet metal of the vehicle’s roof.
• Avoid using the monitor over a
longer period of time while the
engine is off in order to prevent the
battery from becoming discharged.
English
Screws for securing the
mounting plate
Screws for securing the
ceiling-mounted monitor

9
INSTALLING THE MONITOR
Interior lighting connection
(3 wires)
Red wire = Constant +12V
White wire = To the door switch
(Negative Door
Trigger)
Black wire = Ground
Warning notice: The operating voltage
cable must be protected with at least a
1.5 A fuse.
Monitor connection (13 pin)
Use the extension cable and the
plug-in adapter cable to connect to
the 12 V supply voltage and an
external video/DVD device:
Red wire = +12V Ignition
Black wire = Ground
Red RCA plug = Audio In (R)
White RCA plug = Audio In (L)
Yellow RCA plug = Video In
Blue phono plug =
IR pass through for
Blaupunkt DVD
players (DVD-ME2,
DVD-ME3 & DVD-
ME R).
Cables
Extension cable
(13 pin)
Adapter cable
11 12
Interior
Lighting
Connection
System
Cable
11
12