BLUM Tandem User manual

Antaro/Tandemdrawerboxfittinginstructions‐Kitchenunitsonly
68
mm
100
mm
68
mm
100
mm
Support
rod
Drilling
Position
228mm
PanDrawers
StandardheightDrawers
Step1‐Drillingdrawerfronts
Drill1or2mmpilotholesintothe
reverseofyourdrawerfronts,as
showninthediagramsontheright.
Theseholesshouldbe
approximately13mmdeep.
Pleasenote:Non‐standardsizeddrawfrontsmaybedrilledindifferentlocations.
Step2Fittingdrawerfrontbracketsandrods
Onceyouhavedrilledyourpilotholesyoucanfixthebracketsasshownintheimagesbelow.
32
mm
32
mm
Pandrawerswillneedafurtherholedrillingtotakethesupportrods.Usinga10mmdrillbit,
drillanotherholeamaximumof13mmdeep.
Inserttheendofthesupportrodintotheholeandstraightenitouttoexpandtherodendinplace.
Youcanthensnaptheotherendoftherodintothebackofthedrawerasshownabove.
Thedrawerfrontcannowbeadjustedbytwistedtherodsineitherdirection.
Note:Thesemeasurementdonotapplytobedroomunits

Step3‐Fittingandremovingthedrawerfronts
Nowyouhavethebracketsfixedtothedrawerfrontsyoucanconnectthemtothedrawerboxes.
Simplylineupthedrawerbracketswiththedrawerboxasshownbelowandpushtoclipin.
YoucanalsoremovethedrawerfrontifneedsbebyinsertingaPhillipsscrewdriverintotherelease
mechanismandturningtowardsthebackofthedrawerboxasshownbelow.
Step5‐Fittingdrawerboxesontotherunners
Fullyextendthedrawerrunners.Placethedrawerboxontotherunnersasshownbelow.
Slidethedrawerboxbacksquareontherunnersandtheboxwillclickintoplace.
Step4‐Removingdrawerboxesfromtherunners
Fullyextendthedrawerrunners.Liftthefrontofthedrawerboxandthedrawerboxwillclickand
detachfromrunners.Seeimagesbelow.
Step6‐Fittingcovercaps
Placeandclipbackonasshown
below.Toremoveuseaflathead
screwdriverandgentlyremove.
Step7‐AdjustingDrawerFront
A‐HorizontalAdjustment
B‐Drawerfrontremoval
C‐VerticalAdjustment
A
B
FormoreinformationpleasevisittheBlumwebsiteatwww.blum.com
‐
‐
‐
‐
‐
‐
‐
‐
‐
‐
‐
‐
‐
‐
C
ADBF-2015-01