Bradley S19-220DCRPT User manual

P.O. Box 309, Menomonee Falls, WI USA 53052-0309
PHONE 1-800-BRADLEY FAX [phone]
http://www.bradleycorp.com
Installation
215-1256 Rev. E; EN 06-532G
© 2007 Bradley Corporation
Page 1 of 4 4/30/07
S19-220DCRPT
Wall-Mounted Eyewash with
Dust Cover
Table of Contents
Pre-Installation Information . . . . . . . . . . . . . . . .2
Installation Instructions . . . . . . . . . . . . . . . . . . .3
Assembly of Components . . . . . . . . . . . . . . . . .4
Parts List . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4

2
S19-220DCRPT Installation
4/30/07 Bradley Corporation • 215-1256 Rev. E; EN 06-532G
WARNING
Read this installation manual completely to ensure proper installation, then file it
with the owner or maintenance department. Compliance and conformity to drain
requirements and other local codes and ordinances is the responsibility of the
installer.
Separate parts from packaging and make sure all parts are accounted for before
discarding any packaging material. If any parts are missing, do not begin
installation until you obtain the missing parts.
Flush the water supply lines before beginning installation and after installation is
complete. Test the unit for leaks and adequate water flow. Main water supply to
the eyewash should be “ON” at all times. Provisions shall be made to prevent
unauthorized shutoff.
The ANSI Z358.1 standard requires an uninterruptible supply of flushing fluid at a
minimum 30 PSI (0.21 MPa) flowing pressure. Flushing fluid should be tepid per
ANSI Z358.1.
The inspection and testing results of this equipment should be recorded weekly
to verify proper operation. This equipment should be inspected annually to
ensure compliance with ANSI Z358.1.
Workers who may come in contact with potentially hazardous materials should be
trained regarding the placement and proper operation of emergency equipment
per ANSI Z358.1.
For questions regarding the operation or installation of this product, visit
www.bradleycorp.com or call 1-800-BRADLEY.
Product warranties may also be found under ”Product Information” on our web
site at www.bradleycorp.com.
Installation
THIS
SIDE
UP
Packing List
!
!
!
!
P.O.Box309, MenomoneeFalls, WI 53051
R
TESTTHISUNITEACHWEEK
Test-operatevalve(s) each week and sign below.
Reportany malfunctions immediately.
Ventil(e)wöchentlich im Testbetrieb prüfen, bestätigt
durchUnterschrift. Jegliche Störung sofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESESGERÄT1STWÖCHENTLICHZUPRÜFEN.
ESSAIHEBDOMADAIRE
Testle fonctionnement des valves chaque semaine et
signeen bas. S'il y à quelque chose qui ne va pas fait
unrapport immédiatement.
P.O.BOX309, MENOMONEE FALLS,WI 53052-0309 USA
TEL:1-800-BRADLEY FAX: [phone])
http://www.bradleycorp.com
114-051

3
Installation S19-220DCRPT
Bradley Corporation • 215-1256 Rev. E; EN 06-532G 4/30/07
Installation Instructions
NOTE: Flush the water supply line before
beginning installation.
Supplies Required:
• (3) 3/8" wall fasteners and bolts
• Pipe sealant
• Piping to 1/2" IPS water supply inlet on unit
• Sign-mounting hardware
Step 1: Install inlet drain fittings
NOTE: Top of eyewash heads should be 33"-45"
(838mm-1142mm) from floor.
1. Position the inlet drain fitting over the 1-1/4"
drain outlet pipe from wall.
2. Using the inlet drain fitting as a template,
mark the bolt hole locations on wall OR install
three suitable fasteners (supplied by installer)
for 3/8" bolts in the wall at the marked hole
locations (see Figure 1).
3. Bolt the inlet drain fitting to the wall or wall
fasteners using 3/8" bolts (supplied by
installer).
Step 2: Assemble eyewash
1. Assemble eyewash components as shown in
Figure 2 on page 4.
• Apply pipe sealant (supplied by installer) to
all male-threaded pipe joints.
• Use a strap wrench around pipes when
tightening to prevent marring.
Step 3: Connect water supply
1. Connect the water supply piping (supplied by
installer) to the 1/2" IPS inlet on the eyewash.
2. Connect the P-trap and tailpiece to the 1-1/4"
IPS drain outlet on the eyewash.
3. Mount the safety sign to a wall or pipe using
sign-mounting hardware (supplied by
installer).
4. Open the water supply lines. Test for leaks and adequate water flow.
17-1/4"
(438mm)
8-3/4"
(222mm)
21-1/2"
(546mm)
14"
(356mm)
8-3/4"
(223mm)
8-1/4"
(210mm)
4-5/8"
(119mm)
13-5/8"
(346mm)
Ø10-3/4"
(273mm)
2-1/4"
(57mm)
Ø5/16"
(8mm)
MTG.
HOLE
4"
(102mm)
5-1/4"
(133mm)
36" (914mm)
Suggested
Height
To Floor
30-1/2" (775mm)
Suggested
Height
To Floor
Figure 1

Assembly of Components and Parts List
4
S19-220DCRPT Installation
4/30/07 Bradley Corporation • 215-1256 Rev. E; EN 06-532G
1 S90-301 1 Dust Cover /Receptor AssY.
1.1 111-061 1 Inlet-Drain Fitting
1.2 124-028 1 Gasket
1.3 S90-009 1 Dust Cover Assembly
1.4 173-009 1 Cup Strainer
1.5 S21-073 1 Supply Stem
1.6 113-1159 1 Drain Spacer
1.7 S05-100 1 Eyewash Yoke Assembly
1.8 269-651 1 Swivel Stem
1.9 124-055 2 Quad Ring
1.10 139-087 1 Spray Ring Assembly
1.11 110-199 1 Acorn Nut
1.12 269-447 1 Bumper
1.13 161-025 1 Hex Nut
2 113-006LQ 1 Pipe 1/2" IPS x 3-1/2" Long
3 169-025 1 Elbow 1/2" IPS Street
4 S30-072 1 1/2" Valve/Handle Prepack
4.1 S27-282 1 1/2" Ball Valve with Nut
4.11 110-215 1 Nut only
4.2 S08-056 1 Handle Assembly
4.3 142-002DA 1 Lockwasher
4.4 153-372R 1 Adapter
5 269-167 1 Tailpiece
6 269-142 1 Trap
7 114-051 1 Safety Sign
8 204-421 1 Emergency Tag
Item Part No. Qty Description Item Part No. Qty Description
1.6
1.5
Flow Control
This End
1.4
1.3
1.2
1.1
2
4.1
4.3
4.11
4.2
4.4
1/2" IPS
Supply Inlet
1
3
4
1.13
1.7
HANDLE NOTE:
Close the cover and
put the pin through
the clip to keep closed.
1.9
1.11
1.8
1.10
P.O. B ox 309, Menomonee Falls, WI 53051
R
TESTTHISUNIT EACH WEEK
Test-operate valve(s) each week and sign below.
Report any malfunctionsimmediately.
Ventil(e)wöchentlich im Testbetrieb prüfen, bestätigt
durchUnterschrift. Jegliche Störungsofort melden.
Date
Datum
Date
Signed
Unterschrift
Signe
Date
Date
Date Signed
Signed
Signed
DIESESGERÄT1ST WÖCHENTLICH ZU PRÜFEN.
ESSAIHEBDOMADAIRE
Test le fonctionnement desvalveschaque semaine et
signe en bas. S'il y à quelque chose qui ne vapasfait
un rapport immédiatement.
P.O.BOX309, MENOMONEE FALLS,WI 5 3052-0309 USA
TEL:1-800-BRADLEY FAX:[phone])
http://www.bradleycorp.com
114-051
7
8
5
1-1/4" IPS
Drain Outlet
6
1.12
NOTE: Items 1.1–1.13 come presasembled as Item 1.
Figure 2
Prepack S30-087 includes items 4.11, 4.2, 4.3, 4.4