Brita PROGUARD Coffee User manual

PROGUARD Coffee
Instructions | Replacement of Pump (Non-electric)

Note: During the replacement of the non-
electric pump, the coffee machine can neither
be supplied with filtrate nor bypass water.
Required tooling:
- Bucket
-Screwdriver Phillips head (№ 2)
- Collet locking tool 1/4"

Close the shutoff valve
P

Remove the front panel

Open the locking handle of the filter head
P

Open the sampling valve
Empty the storage tank
Close the sampling valve
P

Demount the rear panel (5 screws)

Demounting of the pump used:
Remove the locking clips (4x); keep them safe

Pull the fittings (4x) from the hoses

Pull the pump out of its holder
Remove the remaining locking clips (4x) and
keep them safe (8x in total)

Remove the nipples from the new pump

Mounting of the new pump:
- Insert the included hoses (4x) into the pump
- Secure their position with the locking clips

Important: The sticker must not point outwards
Important: The fins must not be on the right side
O O

Important: The fittings must not be connected to
the incorrect hoses
O
O

Connect the fittings with the hoses (4x)
Attach the locking clips (4x) that you have saved
Push the pump into its holder

Important: Position the fittings vertically to each
other
P

Correct positioning of the pump
P

Open the shutoff valve
P

Close the locking handle of the filter head
Now, the filtrate production will restart
Check the system for leakages
P

Remount the rear panel (5 screws)