Broadfeet DCAC-114-32 User manual

1 | Page
© Broadfeet Motorsport Equipment
Qty Hardware Qty Hardware
2 Mounting Brackets 4 Screw
8 Flat Washer
4 Lock Washer
4 Nut
INSTALLATION INSTRUCTIONS
2014-2015 ACURA MDX
A-BAR PART# DCAC-114-32

2 | Page
© Broadfeet Motorsport Equipment
STEP1: Verify all parts are present. Read instructions carefully before starting installation.
STEP2: Starting from the Driver Side, remove the factory screw shown on Fig1.
STEP3: Cutting on the skid shield for approximately 3” wide and 5” long as shown on Fig2.
Fi
g
1
3”
5”
Fi
g
2

3 | Page
© Broadfeet Motorsport Equipment
STEP4: Cutting on the plastic area shown on Fig3 for approximately 1” wide and 2” long.
STEP5: As shown on Fig4, first remove the factory screw on the right (Marked: A) and then
remove the factory screw on the left (Marked: B). Hold the skid shield while sliding the Driver
Side Mounting Bracket into the 3”X5”opening.
STEP6: Apply WD-40 on the factory screws. And firstly put back the screw on the left [Marked:
B], secondly put back the screw on the right [Marked: A]. Lastly, put back the factory screw
removed from step2 [Marked: C]. (Fig4)
Fi
g
3
Fi
g
4
2”
1”
A
B
C

4 | Page
© Broadfeet Motorsport Equipment
STEP7: Repeat step2-6 for the Passenger Side Mounting Bracket installation.
STEP8: Select the A-Bar and install it on the mounting brackets using 2 Screws, 4 Flat Washers, 2
Lock Washers and 2 Nuts on each side. Tighten all hardware at the end to finish the installation.
(Fig5, Fig6)
Fi
g
5
Fi
g
6
Driver Side installation finished
Driver Side installation finished