Broadfeet DCKI-395-32-40S User manual

Broadfeet)Motorsport)Equipment)) WWW.BROADFEET.COM) Installation)Instruction)
Part)Identification)Number:)DCKI-395-32-40S)|)
Hardware)Included:)
Quantity
Hardware
Quantity
Hardware
1
Bumper Guard
12
Large Washer
2
Mounting Bracket
8
Spring Washer
2
U-Bolt
8
Hexagon Nut
4
Hexagon Bolt
Note:
• Professional installation is highly recommended
• Review and understand the installation hardware and procedure before beginning
• Periodically check the tightness and alignment of the parts for proper adjustment after completion
Diagram 1.A: Refer to the diagram below when fastening nut to bolt. For fastening procedures that does not require
a bracket or bumper, remember the concept demonstrated. The spring should be in between the washer and nut.
Installation Instruction
2015-2017 KIA SEDONA | A-Bar Nudge Bar

Broadfeet)Motorsport)Equipment)) WWW.BROADFEET.COM) Installation)Instruction)
Step 1: Remove under shield plastic skid cover to gain access to the chassis frame
Step 2: Insert U-Bolt as shown. Attach mounting bracket fasten with washer and nut. (Passenger side shown)
Step 2: Install U-Bolt and mounting bracket onto the driver side. (Driver side shown)

Broadfeet)Motorsport)Equipment)) WWW.BROADFEET.COM) Installation)Instruction)
Step 3: Once the mounting brackets are fastened to the U-Bolt, attach the bumper guard. Refer to diagram on Page 1
Passenger Side: (Outer side shown on left image. Inner side shown on right image)
Driver Side: (Outer side shown on left image. Inner side shown on right image)

Broadfeet)Motorsport)Equipment)) WWW.BROADFEET.COM) Installation)Instruction)
Step 4: Adjust and balance the bumper guard and then secure all the hexagon nuts.
Step 5: Re-attach the plastic under skid shield cover.
Additional Diagram:

Broadfeet)Motorsport)Equipment)) WWW.BROADFEET.COM) Installation)Instruction)