Broadfeet DCNI-533-32 User manual

©2014 Broadfeet Motorsport
PARTS LIST:
A
1x Driver/Left Mounting Bracket
F
12x Flat Washers
B
1x Passenger/Right Mounting Bracket
G
6x Nuts
C
1x A-Bar
H
6x Lock Washers
D
6x Bolts
I
2x Flat Washers
E
2x Nuts
J
2x Laper Bolts
INSTALLATION INSTRUCTIONS
A-BAR
13-14 NISSAN PATHFINDER
PART # DCNI-533-32
Vertical section of bracket
*See Fig 1*
A
B
F
D
G
I
E
J
H
Mounting location for A-Bar(C)
Mounting location to
chassis, use Laper Bolt(J)
*See Fig 2*

©2014 Broadfeet Motorsport
**Note: Must remove plastic skid shield, and 2 skirt sides(3 screws on each side)**
Mounting location for vertical end of bracket
Bracket mounting location
Use Laper Bolt(J)
Fig 1
Fig 2

©2014 Broadfeet Motorsport
Position bracket into pipe, keep fitting
loose.
If necessary, cut bumper 1.5 inch wide
1.5 inch high in order to allow the
bracket to go higher
Once the bumper is cut, push the
bracket higher, and tighten the brackets
completely.
D
I
G
Fig 3
F

©2014 Broadfeet Motorsport
Fig 4 illustrates how the
bracket should be sitting after
tightening the mounting bolts
Once the brackets are correctly
positioned, attach the bar.
Position the bar to sit as desired. Once
positioned, tighten the bracket bolts (D)
connecting to the bar(C)
Once the product is in place, reinstall the
skid shield and skirts
*Note* Minor cuts may be required to
the skid shield to reinstall
Fig 4
Fig 5

©2014 Broadfeet Motorsport