Broadfeet RDFO-216-51S User manual

Broadfeet Motorsport Equipment WWW.BROADFEET.COM Installation Instruction
Part Identification Number: RDFO-216-51S
Hardware Included:
Attention:
Please read this installation menu before installing this part. Protect your car properly in case
there is any scratch might have.
You may need to periodically to re-tighten all hardware for safety use after installation.
Installation pictures are only for your reference, there might be some differences between
pictures and real parts but no affect for your fitting.
INSTALLATION PICTURES
NO.
NAME
QTY
REMARK
NO.
NAME
QTY
REMARK
①
Rear Guard
1
⑩
Large Washer
2
φ10x30x2.5
②
Bracket (right)
1
⑪
Spring Washer
2
φ10
③
Bracket (left)
1
⑫
Hexagon Nut
2
M10
④
Hexagon Bolt
4
M12x35
⑬
T Bolt 2-1
2
M8x40
⑤
Large Washer
8
φ12x30x3.0
⑭
Plastic Fixture Φ8
2
⑥
Spring Washer
4
φ12
⑮
Large Washer
2
φ8x25x2.0
⑦
Hexagon Nut
4
M12
⑯
Spring Washer
2
φ8
⑧
T Bolt 4-1
2
M10x40
17
Hexagon Nut
2
M8
⑨
Plastic Fixture Φ10
2
Installation Instruction
2015-2017 FORD EDGE
Rear Bumper Guard Double Pipe

Broadfeet Motorsport Equipment WWW.BROADFEET.COM Installation Instruction
INSTALLATION PROCEDURES
Step 1: Refer to Part List and Installation Picture to check if all hard ware are included.
Step 2: Refer to the following picture to install left and right brackets.
Step 3: Install the rear guard on the brackets and then adjust them to the proper positions.
Step 4: Check if all hard ware are installed and then fasten all to complete the installation.
Disclaimer: Caused due to improper installation initiates some related problem and losses, are beyond our
company’s quality assurance.