Broadfeet RDAC-114-51 User manual

1 | Page
© Broadfeet Motorsport Equipment
Qty Hardware Qty Hardware
2 Mounting Brackets 4 Screw [ for the bar to the brackets ]
4 Screw [ to the chassis ] 8 Flat Washer [ for the bar to the brackets ]
4 Flat Washer [ to the chassis ] 4 Lock Washer [ for the bar to the brackets ]
4 Lock Washer [ to the chassis ] 4 Nut [ for the bar to the brackets ]
INSTALLATION INSTRUCTIONS
2014-2015 ACURA MDX
REAR BUMPER GUARD – DOUBLE PIPE PART# RDAC-114-51

2 | Page
© Broadfeet Motorsport Equipment
STEP1: Verify all parts are present. Read instructions carefully before starting installation.
STEP2: Starting from the Driver Side Rear, locate two holes that closer to the vehicle end. (Fig1)
STEP3: Select the Driver Side Mounting Bracket, bolt it onto the chassis using 2 Screws, 2 Lock
Washers and 2 Flat Washers. (Fig2)
Fig 1
Fig 2

3 | Page
© Broadfeet Motorsport Equipment
STEP4: Repeat step2-3 for the Passenger Side Mounting Bracket installation.
STEP5: Select the rear bumper guard and install it on the mounting brackets using 2 Screws, 2 Lock
Washers, 4 Flat Washers and 2 Nuts on each side. Tighten all hardware at the end to finish the
installation. (Fig3, Fig4)
Fi
g
3 Driver Side Installation Finished
Fi
g
4 Passen
g
er Side Installation Finished
Do NOT use
this hole.
Do NOT use this hole.