Broadfeet DWTO-711-32S User manual

Broadfeet Motorsport Equipment WWW.BROADFEET.COM Installation Instruction
Part Identification Number: DWTO-711-32S
Hardware Included:
NO.
NAME
QTY
REMARK
(1)
Bull Bar
1
(2)
Bracket
2
(3)
Hexagon Screw
2
12-1.75mm x 50mm
(4)
Flat Washer
2
12mm x 37mm OD x 3mm
(5)
Lock Washer
2
12mm
(6)
Flange Nut
6
10-1.25mm
Attention:
Please read this installation menu before installing this part. Protect your car properly in case
there is any scratch might have.
You may need to periodically to re-tighten all hardware for safety use after installation.
Installation pictures are only for your reference, there might be some differences between
pictures and real parts but no affect for your fitting.
INSTALLATION PROCEDURES
Step 1: Please check if all the brackets and hardware are included refers to the Part List.
Installation Instruction
2003-2009 TOYOTA 4RUNNER
2.5" Bull Bar with Skid Plate

Broadfeet Motorsport Equipment WWW.BROADFEET.COM Installation Instruction
Step 2: Remove 3 factory hexagon nuts, 2 from the outside and 1 from the frame channel. Securing the bumper
bracket to the end of the frame channel. (Ref. Pic 1) (Note: Only remove the 3 factory hex nuts to install
the mounting brackets.)
Step 3: Hang the left bracket from the thread studs. Secure the mounting bracket to the bumper bracket with the
included Flange Nuts. Snug but do not tighten hardware at this time. It is the same way to install the
other mounting bracket.
Step 4: Line up the ends of the Bull Bar with the previously installed Frame Mounting Brackets. Bolt the Bull Bar to
the Frame Mounting Brackets with the included (3), (4) and (5). Snug but do not tighten hardware at this
time.
Step 5: Level and adjust Bull Bar properly and tighten all hardware, including the hardware on the Mounting
Brackets.
Step 6: Complete the installation.
Disclaimer: Caused due to improper installation initiates some related problem and losses, are beyond our
company’s quality assurance.