Broadfeet DCNI-523-32 User manual

1 | Page
© Broadfeet Motorsport Equipment
Qty Hardware Qty Hardware
2 Mounting Brackets 2 Z-Bolts
6 Screws
8 Nuts
10 Lock Washers
16 Flat Washers ( Big flat washers*2, Small flat washers*14 )
INSTALLATION INSTRUCTIONS
2015 NISSAN MURANO
2.5” A-BAR PART# DCNI-523-32

2 | Page
© Broadfeet Motorsport Equipment
STEP1: Verify all parts are present.
Read instructions carefully before
starting installation.
Z-Bolt

3 | Page
© Broadfeet Motorsport Equipment
Driver Side Installation
Fi
g
2
STEP2: Starting on the driver side
of the vehicle, locate a factory hole
and insert a Z-Bolt in it. (Fig1)
Fi
g
1
STEP3: Slide in the driver side
mounting bracket in an angle
and rotate into place, then use a
lock washer, a flat washer and a
nut to attach the Bracket Rear
on the vehicle. Tighten the
hardware. (Fig2)

4 | Page
© Broadfeet Motorsport Equipment
Fi
g
3
Fi
g
4
STEP4: Use a bolt, a lock
washer, a small flat washer
and a big flat washer to
attach the Bracket Middle on
the vehicle. Tighten the
hardware. (Fig3, Fig4)

5 | Page
© Broadfeet Motorsport Equipment
Passenger Side Installation
Fi
g
5
Fi
g
6
STEP5: Repeat steps 1-4 for
the passenger side bracket
installation. Tighten the
hardware. (Fig5)
STEP6: Use bolts, lock
washers, flat washers and nuts
to attach the A-Bar to
mounting brackets. Level and
adjust A-bar properly. Tighten
all hardware at this time. (Fig6)