BROSA Baker Console Table User manual

ASSEMBLY GUIDE
Baker Console Table
v1.0

Components
Leg x 2
Leg Base x 2
Middle Rail x 1
Mounting
Plate x 2
Table Top x 1
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
5
1
3
4
2
A x 6
(Dowel)
(Ø8 x 30)
B x 2
(Steel Dowel)
(M8 x 10 x 48.5)
C x 2
(Grub Screw)
(M10 x 10)
D x 4
(M8 Short Bolt)
(M8 x 35)
E x 1
(M5 Allen Key)
(M5 x 30 x 107)
F x 1
(M4 Allen Key)
(M4 x 30 x 107)
G x 4
(Long Bolt)
(M8 x 70)
Hardware
What you need
H x 16
(M6 Short Bolt)
(M6 x 35)

Step 1 Insert two dowels (A) into the diagonal holes on the
mounting plate (2). Repeat this for the second
mounting plate.
A x 2
Step 2 Align a leg (3) with the leg base (4) and the mounting
plate (2). Attach the parts together. Secure the base
with long bolts (G) using the Allen key (F) and the
mounting plate (2) with M8 short bolts (D) using the
M4 Allen key (F).
F x 1
G x 4
D x 4
D
D
F
A
A
G
G
F
2
2
4
3

Step 3 3.1 Screw a steel dowel (B) into the side hole on the
leg base. Ensure that the hole is facing the bottom as
shown in the diagram. Repeat this for the other leg.
3.2 Insert wooden dowels (A) into the holes on each
end of the middle rail (5).
B x 2
Step 3.1
Step 3.2
A x 2
B
A
5

Step 4 Align one of the formed leg structures with the
underside of the table top (1) so that the holes
overlap. Secure them with short M6 bolts (H) using
an allen key (F).
H x 8
1
H
F
F x 1

Step 5 5.1 Attach the stretcher (5) to the leg that was xed
in the previous step. Attach the second leg to the
stretcher and make sure that the holes on the
mounting plate are aligned with the holes on the
table top.
5.2 Secure the leg with M6 short bolts (H) using the
M4 Allen key (F).
Step 5.1
Step 5.2
H
F
5
H x 8
F x 1

Step 6 Secure the stretcher with grub screws (C) using an
M5 allen key (E).
C x 2 E
C
E x 1

Step 7 Place the table upright on a level surface.
Enjoy your new table!