BROSA Lucille Round Table User manual

Lucille
Round Table
A S S E M B LY GU I D E
V2

FOR YOUR SAFETY
Lift, don’t drag. This protects
your floor and product.
Avoid loose screws. Tighten
fixtures every few months.
Assembly requires 2 people.
It's always easier with a
friend.
Contact our support online
or call 1300 027 672.
Check the assembly guide
for required components.
?
Assembling this product on
a soft surface protects its
finish.

Components
Before you get started, check you have all of the pieces below.
If anything’s missing, we’ll sort it out right away. Simply visit:
www.brosa.com.au/pages/product-return-and-parts-request
Table Top x 1 (See Step 1, Step 2 for access.)
①
Hardware
What You Need
E x 1
(M4)
A x 8
(M6 x 70)
B x 10
(M6)
C x 1
(M6 x 55)
D x 1
(M6 x 45)
Upper Leg x 1 Lower Leg x 1
② ③

Step 1 Upon unpacking your shipping carton, you should
have the cement table top fixed and secured by
the wooden crate. Untighten the screws fastening
the slats together to disassemble the crate.
Cement is a relatively fragile material. To prevent the cement table top
from damage during transportation, an extra wooden crate has been
applied. Please follow Step 1 and Step 2 below to unpack the table
top.

Step 2 Remove all the wooden slats so that the inner box
is separated from the crate.

Step 3 Unscrew the bolts attached to the wooden block.
Take off the bolts so that the block is separated
from the leg frame ③. Keep the removed bolts
and flat washers for the following assembly.
E x 1
③
E

Step 4 Fit the lower leg ③ and upper leg ②together as
shown in the diagram below.
Fit a washer B to the medium bolt Cand then
insert the bolt into the hole in the middle. Tighten
the bolt with the Allen key E.
E
C
B
②
③
B x 1
C x 1
E x 1

Step 5 Fit the wooden block removed in Step 3 back
into the recess formed in Step 4.
Insert the bolts and washers removed in Step 3
back into four corners.
Fit a washer B to the short bolt Dand then insert
it into the middle.
Tighten all bolts with the Allen key E.
B x 1
D x 1
E x 1
E
D
B

Step 6 Gently place the table top ① on a flat soft sur-
face with the bottom facing upward. Align the
structure formed in Step 5 with the bottom of the
table top and make sure the bolt holes on each
side overlap.
Fit a washer B to a long bolt A and insert the bolt
into a hole. Tighten the bolt with your hand until it
is finger-tight. Repeat this for the remaining
holes.
A x 8
B x 8
①
A
B

Step 7 Tighten all bolts with the Allen key E.
E x 1
E