BROSA Haruki Console Table User manual

ASSEMBLY GUIDE
Haruki Console Table
v1.0

Components
Upon unpacking your table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new table.
Table top x 1
Left side panel x 1
Right side
panel x 1
Drawer
box unit x 1
Left drawer x 1
Right drawer x 1
Hardware
What you need
A x 4
Spec: Ø8 x 30mm
D x 8
Spec: Ø8 x 35mm
E x 1
Spec:
B x 4
Spec: Ø7 x 44.5mm
C x 4
Spec:

Step 1 1.1 Insert a dowel (A) into the holes on both sides of the
drawer box (4) as shown below.
1.2 Insert the cam screws (B) into the side panels (2 & 3)
along the bottom on either side and using the pozi
screwdriver to tighten in place.
Step 1.1
Step 1.2
A x 4
B x 4

Step 2
C x 4
2.1 Stand the drawer box unit (4) in a vertical position
and align side panels (2 & 3) one by one to their
corresponding sides, making sure all the dowels (A)
and cam screws (B) align to their correct holes and
rmly press together.
2.2 Insert the cam locks (C) into the holes along the
underside of the drawer box unit (4) to secure the side
panels (2 & 3) into place. Using the pozi screwdriver to
tighten the cam locks (C).
Step 2.1
Step 2.2

Step 3 3.1 Align the structure assembled in Step 2 to the
underside of the table top (1) so all corresponding
holes match.
3.2 Insert a bolt (D) into each hole and screw into place
to secure the side panels (2 & 3) to the table top (1).
Use the allen key (E) to tighten all bolts.
3.3 Gently lift the table and rmly place upright on a
level surface. Enjoy your new table!
D x 8
E x 1
Step 3.1
Step 3.2
Step 3.3

Step 4 e following steps are to intruct how to remove and
insert the drawers.
4.1 To remove the drawers, pull them out one by one
and unlock by lifting up both locking pads located on
either side of the drawers and then remove it.
4.2 To insert the drawers, align it to the unit one by one
and push back inside and once the drawer is in place
the locking pads on both sides will automatically lock.
Step 4.1
Step 4.2