BROSA Brunswick 175cm Dining Table User manual

ASSEMBLY GUIDE
Brunswick 175cm Dining Table
v1.0

Components
Upon unpacking your table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new dining table.
Table top x 1
Hardware
What you need
A x 6 B x 6 C x 2 D x 1 E x 1
1
Leg frame x 2 Support rail x 1
2
3

Step 1 Place the table top (1) on a level surface, making sure
the underside is facing you. Align a leg frame (2) to
the underside of the table top so that the screw holes
are overlapping. Fit a plastic washer (B) to a sheet
metal screw (A) and screw into the hole with a span-
ner (D) but do not tighten yet. Repeat for the
remaining holes and then repeat for the other leg
frame.
Step 2 Align the support rail (3) with the leg frames so that
the screw holes are overlapping. Insert a bolt (C) into
a hole and screw with the allen key (E) but do not
tighten yet. Repeat for the screw hole on the other
side.
C x 2
E x 1
A x 6
B x 6
D x 1
1
2
2
A
B
C
D
3
E

Step 3 Tighten all screws and bolts with the spanner and
allen key.
Step 4 Gently lift the table and place upright on a level
surface. Enjoy your new dining table!
E x 1
D x 1