BROSA Henry Scoop Back Dining Chair User manual

ASSEMBLY GUIDE
Henry Scoop Back Dining Chair
v1.0

Components
Upon unpacking your chair from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new chair.
Chair body x 1
Support beam x 1
Chair leg x 2
What you needHardware
A x 4
Spec: Ø6 x 35mm
B x 4
Spec: Ø6 x 10 x 1.8mm
C x 4
Spec: Ø6 x 16 x 1.5mm
D x 2
Spec: Ø4 x 30mm
E x 1
Spec:

Step 1
D x 2
C x 4
B x 4
A x 4
E x 1
1.1 Align the support beam (03) to both of the legs
(02) and with another person, insert the screws (D)
into the holes and screw tightly in place with a
phillips head screwdriver.
1.2 Align the structure (02 & 03) to the body of the
chair (01) so that the screw holes are overlapping
and have another person hold it in place. Fit a spring
washer (B) to a bolt (A) followed by a washer (C) and
screw into each hole. Use the Allen Key (E) to tighten
all parts into place.
Step 1.1
Step 1.2

Step 2 Turn upright and place the chair on a level surface.
Enjoy your new dining chair!