BROSA Cooper Tub Armchair User manual

ASSEMBLY GUIDE
Cooper Tub Armchair
v1.0

Components
Upon unpacking your chair from it’s delivery box, you should have one single
component (the body of the chair). Additional components are packed inside
the body, you will learn how to access and utilise these components in the
next steps.
Turn the chair body so that the underside is facing you. Follow the coloured
string to the component compartment. Unzip this and take out the
additional components, then zip it back up.
Chair body x 1
Unpacking
A x 4 (Leg)
B x 4 (Bolt)
C x 4 (Washer)
D x 1 (Allen Key)

Step 1
D x 1
C x 4
B x 4
A x 4
Align a leg (A) so that the screw slots are overlapping.
Fit a washer (C) to a bolt (B) and t it into one of the
screw holes. Repeat for the second screw to t the leg
onto the body of the chair. Turn the bolt with the
allen key (D) until it is secure but do not tighten yet.
Repeat for all four legs.
Step 2 Lift the chair o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the chair.
A
D
B
C

D x 1
Step 3 Place the chair on a at surface, then sit on the chair
and shift your weight around until the legs are level
and the chair does not rock. en use the allen key
(D) to tighten all the bolts. Enjoy your new armchair!