Canon CREATIVE PARK Pop-up Card User manual

Pop-up Card(Christmas Wreath): Assembly Instructions
Cut out the parts and crease them along the fold lines indicated.
Cut a slot into each side of the ribbon and assemble together.
Attach 2 to the glue tab area of the wreath.
Rotating stand
Message Plate
Holly (left)
Wreath
Ribbon (left) Ribbon (right)
Holly (right)
A glue tabs B glue tabs

Pop-up Card(Christmas Wreath): Assembly Instructions
Attach the base together at the glue tab.Cut the slots on the A glue tabs, and slot them together so that
only the white area can be seen (2 sets).
Attach the glue tabs on the B glue tabs to make a stand (2 sets).
Attach 4 to the message plate. Attach the rotating stand to the base.
Attach 5 to the inner most glue tab on the rotating stand (8).

Pop-up Card(Christmas Wreath): Assembly Instructions
Add decorations to the wreath - it's up to you!
Place 3 on top of 10. Attach the rotating stand's glue tabs to
the A glue tab at the top, and secure 3.
*After attaching the rotating stand and 3 together and deciding
the position, add some glue to the A glue tabs on the message plate.
Attach the wreath by pressing it from the top.
Attach 6 to 9's message plate. Then, attach the left and
right holly leaves on top of it.
Stick on a colored paper cover onto half of the rear side of the base paper.
Be careful to stick it on in the right direction.
13 is the completed card when the cover is stuck on to the other half side.