Car Solutions CarPlay User manual

Instruction Manual
CarPlay
[email protected] car-solutions.com
Car-Solutions.com

INDEX
Specifications
1. Main Spec. ----------------------------------
2. Components---------------------------------
3. Exterior --------------------------------------
Settings ------------------------------------------
Installation
1. Connection ----------------------------------
2. Caution --------------------------------------
2
3
4
5
6
7
8
[email protected]
car-solutions.com
Car-Solutions.com

Specification
1. Main spec.
3
1-1. Input Spec.
- 1 x USB Input
- 1 x Microphone Input
- 1 x Real Analog Touch Input
1-2. Output Spec.
- 1 x LVDS(HDMI Connector) Output
- 1 x Audio L/R (3.5ФStereo Jack) Output
- 1 x Mono Speaker
1-3. Power Spec.
- Input Power : 8VDC ~ 24VDC
- Consumption Power : 12Watt, Max
[email protected]
car-solutions.com
Car-Solutions.com

Specification
2. Components
4
Interface 1 EA
AUX Cable 1 EA
Power Cable 1 EA
SPEAKER Cable 1 EA
HDMI Cable 1 EA
TOUCH Cable 2 EA
Microphone 1 EA
[email protected] car-solutions.com
Car-Solutions.com

Specification
3. Exterior
5
[email protected] car-solutions.com
134.5mm 23mm
82mm
*Touch Connect
①Y-
②X-
③Y+
④X+
①②③④
*POWER Connect
①ACC
②GND
①②
Speaker
AUX
LVDS&UART
OUT
Smartphone
Connection
Touch
Calibration
Microphone In
Car-Solutions.com

Settings
6
1. Press the setting button for 3 seconds. 2. When the above menu appears,
press the setting button for 3
seconds.
3. Calibrate the touch screen
[email protected]
car-solutions.com
Car-Solutions.com

7
Installation
Connection
Iphone
Screen
Microphone
Screen
Screen
AUX
3.5pie aux cable
Interface
[email protected] car-solutions.com
Car-Solutions.com

8
Caution
•Not possible to switch mode
- Check connection of OSD Key pad wire
- Check CAN connection
•Display wrong size of picture
- Check Dip s/w setting
•Display black screen in OEM mode
- Check connection of LVDS/LCD cable
•Not possible to switch to rear screen
- Check the packing setting
(OSD Menu –option –RearCam-Det)
1. FAQ
•The device must not be installed in where it interferes driving
(close to brake pedal, steering wheel, airbag etc.)
•LVDS cable must be connected correctly according to the manual
•Insulate the end of wire by using electrical tape
•The installation should be done by expert
•GU electronic does not take any responsibility for any problem
caused by wrong installation
2. Caution
[email protected]
car-solutions.com
Car-Solutions.com