Car Solutions MB10 Series User manual

MB10
(W221 2010 MODEL)
Installation
Last Updated : 2011.08.23
MODEL : QVL-MB10-RND-V1 / Product code : MB10-RND-V1-1001-000
www.Car-Solutions.com

Contents
2
1 Installation diagram
2 Cautions on installation
3 Installation
3
4
5
www.Car-Solutions.com
[email protected]

1 Installation diagram
3
MODE
Remote
RGB(IN) A/V(IN/OUT)
VIDEO INTERFACE (W221/W204)
DIP S/W
LED
POWER
Monitor
CAN
LVDS-OUT
Control Box
Offered LCD cable
CAN High
CAN Low
Original LCD cable
SET OUT
NAVI-SEL
AV1-SEL
REAR-SEL
TO LCD
FROM I/F
LCD-IN R DATA (red)
G DATA (green)
B DATA (blue)
N.C
SYNC (white)
GND (black)
N.C
AV1 AV2 AV3
REAR C
Audio L Audio R
AV/OUT Video
REAR-C
SAFE
F-CAM-DET
CAN-L
CAN-H
ACC (12V ~24V)
GND
www.Car-Solutions.com
[email protected]

2 Cautions on installation
4
Ignition key should be taken off before starting installation, interface power connection must be
the last step in installation.
Power cable should be separated when connecting interface.
Should be no any electronic devices or magnetic pole around installation place.
All steps of installation should be done by well-trained specialist.
Dismantling without manufacturer’s permission can not be guaranteed, (No permission to break
attached label on the board.)
Kindly check all parts are in the box, when receiving the product, if anything missing, inform to the
supplier or manufacturer.
According to our sales policy, any problems caused by user’s mistake, careless can not be
guaranteed.
www.Car-Solutions.com
[email protected]

3 설치(New S, C-class)
5
LCD IN/OUT cable connection
CAN wire connection
Connect offered CAN wires to CAN wires from car.
- White + Black : CAN High
- Black : CAN LOW
Connect the Original LCD cable into LCD-IN input of the
interface board and offered LCD-Out cable into the Monitor.
www.Car-Solutions.com
[email protected]