Car Solutions 871912 User manual

REV 1.1 07/06/2018
www.car-solutions.com [e-mail]
Adjusting Parking Lines
After the aftermarket rear view camera has been installed, the car monitor will display static and dynamic parking lines
on the camera image.
Static lines: lines with colored indicators that show distance to obstacles.
Dynamic lines: lines that turn depending on the steering wheel.
Depending on the camera view angle and the place of installation, parking lines may not be informative and will then
need to be adjusted in the diagnostic menu of the car radio.
Note! Car Solutions is not liable for any damage or incorrect equipment operation in case of improper installation.
Below is the procedure for entering the car radio diagnostics menu to get line settings adjusted. Follow the instructions
precisely to avoid unforeseen complications or car radio damage. If such complications occur, turn off the car radio. To
do that, remove the front panel of the radio and disconnect all wires for several minutes.
Press the car radio sound button on the display .
Audio OFF pop-up message should appear at the
bottom of the screen.
Note! Depending on your car radio model, various
buttons may differ from those shown on the picture.
1. Press the INFO/MAP button three times
2. Press the button two times
3. Press the INFO/MAP button one time
Note! Depending on your car radio model, the INFO or
MAP button may be in the top right corner.
Car-Solutions.com

REV 1.1 07/06/2018
www.car-solutions.com [e-mail]
Choose the Confirmation/Adjustment option in the
menu that appears.
Note! In some cases you may not manage to enter the
diagnostics menu from your first try, just try doing it
again if it didn’t work.
Move to the next page of the service menu using the
Down button.
Note! Depending on your car radio model and its
software version, some menu options may be placed
and/or called differently.
Choose the Camera option in the menu that appears.
Note! Depending on your car radio model and its
software version, some menu options may be placed
and/or called differently.
Choose the Correct Draw Line of Rear View Camera
option in the menu that appears.
Note! Depending on your car radio model and its
software version, some menu options may be placed
and/or called differently.
Image from the connected camera will be activated
with OSD buttons for adjustment of parking lines and
camera image. Align parking lines relative to the center
of the image and adjust the lines accordingly.
Car-Solutions.com

REV 1.1 07/06/2018
www.car-solutions.com [e-mail]
Place various obstacles on specified distances behind
your car and make required adjustments.
Note! In case rear view camera was installed
near/above the license plate or into the license plate
backlight, the rear bumper will not be visible on the
camera image.
Checking Camera Activation Signal
If your car radio was not installed by the manufacturer, the backup activation signal may be absent from the
wires connected to the car radio. For cases like this there’s a grey REV wire in our cable. +12 V should be supplied to this
wire when the car is switched to reverse (may be taken from the rear lamp). Also, you may check the connection of this
activation signal in the diagnostics menu.
Enter the diagnostics menu using the method described
at the beginning of this manual. Choose the Vehicle
Signals option in the first window.
Note! Depending on your car radio model and its
software version, some menu options may be placed
and/or called differently.
Check the Reverse signal in the dialog window that
appears. ON message should appear on the screen
when you switch to reverse, and disappear when you
switch back. If this does not happen (there’s no
message or it does not react), use the grey REV wire of
our cable.
Press the BACK button in the top right corner to exit
the diagnostics menu.
Car-Solutions.com