Car Solutions Peueot2017 RCC TD User manual

Instruction Manual
PEUGEOT2017 RCC TD for PEUGEOT
Car-Solutions.com
[email protected]
car-solutions.com

INDEX
Specifications
1. Main Spec. ----------------------------------
2. Diagram -------------------------------------
3. Components --------------------------------
4. Exterior --------------------------------------
Settings
1. Dip Switch ----------------------------------
2. Original button -----------------------------
3. Touch(DVD, DTV control) -------------------
4. Key board -----------------------------------
5. OSD Menu ----------------------------------
Installation
1. LVDS Installation ---------------------------
2. Caution -------------------------------------
2
3
4
5
6
7
9
12
14
14
22
23
2
Car-Solutions.com
[email protected]
car-solutions.com

Specification
1. Main spec.
1-1 Input Spec. (MULTI VIDEO INTERFACE)
- 1 x CVBS(REAR CAMERA) Input. (Rear camera source)
- 1 x CVBS(FRONT CAMERA) Input. (Front camera source)
- 1 x Analog RGB Input (Navigation System output)
- 1 x Digital RGB Input (Navigation System output)
- 1 x LVDS Input. (Car Command System)
1-2 Output Spec.
- 1 x LCD Output (LCD Operation)
1-3 Power Spec.
- Input Power : 8VDC ~ 24VDC
- Consumption Power : 12Watt, Max
1-4 Switch Input mode
- Possible to switch input mode through original button
2. Features
- Possible to register IR code of DVD/DTV
- Display dynamic PAS(Parking assistance system)
- Easy installation by Jack by jack
3
Car-Solutions.com
[email protected]
car-solutions.com

Specification
2. Diagram
4
INTERFACE
Scaler
(PIP)
MCU
LVDS
TX
CAR
COMMAND
SYSTEM CAN
EEPROM
CAN
RECEIVER
LVDS
TX
CAR
TFT-LCD
LVDS
RX
RELAY
REAR CAMERA
POWER
REAR CAMERA
LVDS
LVDS
RGB
NAVIGATION
SYSTEM
FRONT CAMERA
LVDS
NAVIGATION
SYSTEM LVDS RGB888
Car-Solutions.com
[email protected]
car-solutions.com

Specification
3. Components
5
Power Cable 1EA
LVDS Cable 1 EA
RGB NAVI Cable(7pin) 1EA
Touch Cable(KD-900) 1EA
OSD Board 1 EA
NAVI Power Cable(300mm) 1 EA
Car-Solutions.com
[email protected]
car-solutions.com

Specification
4. Exterior
168 mm
22 mm
6
83 mm
*NAVI Connect
① R DATA (Red)
②G DATA (Green)
③B DATA (Blue)
④SYNC (White)
⑤GND (Black)
⑥DVB-T IR (Green)
⑦DVD IR (Orange)
①②③④⑤⑥⑦
*Touch Connect
① Y-
②X
③Y+
④X+
① ② ③ ④
*POWER Connect
①ACC (Yellow)
②REAR PWR (Red)
③CAN-H (Orange)
④CAN-L (Green)
⑤REAR DET (Brown)
⑥GND (Black)
①②③④⑤⑥
*Navi Connect
① BATTERY
②ACC
③N.C
④GND
① ② ③ ④
Car-Solutions.com
[email protected]
car-solutions.com

Settings
1. Dip Switch
* ON : DOWN , OFF : UP
NO. Function Selection
1 NAVI ON : Skipping NAVI
OFF : Display
2 AV1 (DVB-T) ON : Skipping Video
OFF : Display
3 AV2 (DVD) ON : Skipping Video
OFF : Display
4,5 N.C
6
Car Model
OFF : 2017 Peugeot 3008,
2017 Citroen C4 PICASSO
7OFF : 2017 Peugeot 3008,
2017 Citroen C4 PICASSO
8ON : 2017 Peugeot 3008
OFF : 2017 Citroen C4 PICASSO
* Example
2017 Peugeot 3008 2017 Citroen C4 PICASSO
7
2017 Peugeot 208
Car-Solutions.com
[email protected]
car-solutions.com

8
※ Possible to use “Front, Rear” input as video input for DTV, DVD (DTV, DVD UI ICON
appears only in Front input)
ON 2 3
NAVI
OEM DTV(AV1)
ON 2 3
NAVI
OEM DVD(AV2)
•FRONT
•REAR
“RearCam-Type” should be set as “OEM” and
“AV Mode” should be set as “ON” in OSD Menu
when video device is connected to Rear input
No.2: Off / No.3: On
DVB-T UI On/Off (Refer to P16)
(Dip no.3 should be ON (Skip) Otherwise AV2 screen will appear)
No.2: On / No.3: Off
DVD UI On/Off (Refer to P16)
((Dip no.2 should be ON (Skip) Otherwise AV1 screen will appear.)
- AV1 Setting – For DTV
- AV2 Setting – For DVD
- AV Setting – For DTV or DVD
Settings
1. Dip Switch- DVB-T, DVD Setting
NAVI
OEM DTV(AV1)
or DVD(AV2)
AV
(DTV or DVD)
Car-Solutions.com
[email protected]
car-solutions.com

9
Settings
2. Original button Peugeot 3008, PICASSO (Switching Mode)
※ The screen is switched in order as the pictures below
2017 Citroen C4 PICASSO
2017 Peugeot 3008
Long Press or Short Press : Switching Mode
※ You can choose the Switching mode type
(Long Press or Short Press ) from the OSD Menu (P.17)
- Long Press
- Shot Press
Car-Solutions.com
[email protected]
car-solutions.com

10
Settings
2. Original button Peugeot 208 (Switching Mode)
NAVI AV1 AV2OEM
※ The screen is switched in order as the pictures below
※ Possible to set the use of MENU buttons ON or OFF in OSD menu (P.16)
Long Press : switching mode
2017 Peugeot 208
Car-Solutions.com
[email protected]
car-solutions.com

11
Settings
2. Original button – Steering Wheel (Switching Mode)
NAVI AV1 AV2OEM
※ The screen is switched in order as the pictures below
※ Possible to set the use of SRC button ON or OFF in OSD menu (P.16)
Long Press : switching mode
2017 Peugeot 208
2017 Peugeot 3008
2017 Citroen C4 PICASSO
Car-Solutions.com
[email protected]
car-solutions.com

12
Touch OEM screen in any mode more than 7sec.
For calibration
(This function can be activated only one time
after switching mode)
Touch the “+” correctly
- DVB-T/DVD Control
Press Touch (Anywhere) Press Icon
DVB-T
DVD
Settings
3. Touch screen – Touch calibration
Car-Solutions.com
[email protected]
car-solutions.com

13
Settings
3. Touch screen – DVD, DTV control
•DTV – Please contact a supplier in advance for using this function
[Button type-1] [Button type-2]
•DVD
※ Calibration : Touch any point of screen more than 7sec to start a touch calibration
[Power] [Search] [Up] [Down]
[Power] [Menu]
[Return][USB]
[Stop]
[DVD up]
[Play/pause]
[Power]
[MIC]
[Rewind]
[Play Previous
chapter]
[DVD down]
[FF]
[Play Next
chapter]
※ To use this function, It is necessary to offer the remote IR code to manufacturer
or setting OSD IR – Ctrl（P. 21）
Car-Solutions.com
[email protected]
car-solutions.com

Settings
4. OSD Key board
5. OSD Menu
※Press “MENU” button on Key board
14
① MENU :Activating OSD Menu
② SEL :Selection
③ Up :Moving upward (Increasing value)
④ Down :Moving downward (Decreasing value)
MENU SEL UP DOWN
①②③ ④
Config - NAVI-RGB : Setup for the type of NAVI-RGB
Config - DVB-T(DMB) : Setup for the type of DVB-T(DMB)
Config - DVD : Setup for the type of DVD
Reset : Reset all value
Car-Solutions.com
[email protected]
car-solutions.com

15
Settings
5. OSD Menu
※Press “MENU” button on Key board
Option
•RearCam-Type : Setup for rear camera
ExtDevice - External rear camera
OEM - Original camera
•RearCam-Power : Setup for Rear VCC wire in power cable
ON - +12V out always (current consumption : 200mA)
AUTO - +12V out in rear mode only (200mA)
OFF - Power OFF
•RearCam-Det : Setup for Rear detection
CAN - By CAN
WIRE - by rear cam detect wire
OFF - Rear detection OFF
•AV Mode : Change “Rear” input as Video input
ON – Video input (Rearcam TYPE in OSD menu should be “OEM”)
OFF – Rear input
•FrontCam-Type : Setup for front camera
ExtDevice - External rear camera
OEM - Original camera
Car-Solutions.com
[email protected]
car-solutions.com

16
Settings
5. OSD Menu
※Press “MENU” button on Key board
Option
•FrontCam-RcvOpt : Selecting time of displaying Front camera before switching to RG
B,
DVD, OEM from Rear
•Steering Wheel Btn : Setting for Steering wheel button (Switching Mode)
ON - ON
OFF – OFF
•Button : Setting for Original Button (Peugeot 208 Switching Mode)
ON - ON
OFF – OFF
•UI DVB-T(DMB) : Setting UI ICON - ON or OFF
•UI DVD : Setting UI ICON - ON or OFF
OEM
NAVI
AV1(DVB-T)
AV2(DVD)
REAR FRONT
OEM
NAVI
AV1(DVB-T)
AV2(DVD)
Select time of display
1~30 second
Car-Solutions.com
[email protected]
car-solutions.com

17
Settings
5. OSD Menu
※Press “MENU” button on Key board
Option
•NAV Btn : Setting for Original Button (Peugeot 3008, PICASSO Switching Mode)
SHORT - Short Press
LONG - Long Press
OFF - OFF
•NAVI COM (N.C)
•Reset : Reset all value
Car-Solutions.com
[email protected]
car-solutions.com

18
MENU IMAGE NAVI
Config
Option
Image
Screen
Parking
Brightness
Contrast
Color- RED
Color- GREEN
Color- BLUE
50
50
50
50
25
MENU Screen NAVI
Config
Option
Image
Screen
Parking
Horizontal
Vertical
Scale X Up
Scale X Down
Scale X Up
50
50
50
50
50
MENU IMAGE Rear
Config
Option
Image
Screen
Parking
Brightness
Contrast
Saturation
Hue
Sharpness
50
50
50
50
25
- NAVI(RGB) Image / Screen
- DVD, DVBT, NAVI-AV, REAR, FRONT Image
Settings
5. OSD Menu
※Press “MENU” button on Key board
Image
Screen
Image
Car-Solutions.com
[email protected]
car-solutions.com

Settings
- Parking guide line ON/OFF
Selecting a use of packing guide line
(OSD Menu – Parking – Line display – ON
or OFF)
19
Parking line “ON”
MENU SEL UP DOWN
Left Right Down
UP
- Adjust the position of Parking guide line
Possible to adjust the position of line
by Keypad in Horizontal / Vertical menu
※ Pressing this Horizontal / Vertical menu,
The OSD screen automatically disappears.
Please adjust from the parking line Screen.
- Warning Language for rear screen
Selecting a type of language (OSD Menu – Parking – Warning Lang)
5. OSD Menu
※Press “MENU” button on Key board
Car-Solutions.com
[email protected]
car-solutions.com

20
- OSD
- IR – Ctrl (p.21)
- Utility
•Utilityy– INTERFACE SOFTWARE
•OSD – Horizontal
•OSD – Vertical
•OSD – Display : Setting time for displaying OSD menu
•OSD – Transparency
•OSD – Language : Setting language of ODS menu
Settings
5. OSD Menu
※Press “MENU” button on Key board
- 170612
Car-Solutions.com
[email protected]
car-solutions.com