Cardinal Health Kangaroo Connect Enteral Feeding Pump User manual

Quick start directions
Cardinal Health™
Kangaroo™ Connect
Enteral Feeding Pump
Pump overview
Set up the pump
Prime the pump
1. Soft keys
Press a key to select the option that
appears next to it on the screen.
2. Power button
Press once to power on.
Press and hold to power o.
3. Power source
A green light shines when the pump
is connected to AC power.
4. Pump status
= Warning alarm
= Notice or caution alarm
= Standby or feeding
1. Press the power button. 2. Load set by inserting
from the bottom and
snapping into place.
3. Select Prime.
1. Select Priming mode. 2. If you selected
Auto Prime, wait.
3. If you selected Hold
To Prime, press and hold
Prime Feed until uid
reaches end of tubing.
1
1
1
2 3
4
3
3
2
2

Start a feeding
Ensure the correct fluid level Power down the pump
2. Use the plus (+) and
minus (-) buttons to enter
the rate, then select OK.
5. To resume feeding,
select Continue.
1. Select Clear Settings.
4. To suspend the
feeding, select Pause.
3. When ready to begin
feeding, select Start.
1. Make sure the top of the uid
column is placed 10 in. (25.4cm)
above the top of the pump.
1. Press and hold the power button
for 3 seconds.
1
4 5
2
3
1
1
10 in. (25.4cm)
© 2020 Cardinal Health. All Rights Reserved. CARDINAL HEALTH, the
Cardinal Health LOGO, ESSENTIAL TO CARE and KANGAROO are trademarks
or registered trademarks of Cardinal Health. All other marks are the property
of their respective owners. Lit. No. 2SP20-1150808 (4/2020)
cardinalhealth.com
Cardinal Health
7000 Cardinal Place
Dublin, Ohio 43017
For additional operations or information,
see the Kangaroo™ Connect enteral
feeding pump operations manual.