QuickStartfor the EL Model telephone entry/access control systems
This QuickStart is intended to highlight a typical single family home application with one phone line. These instructions are not intended to be comprehensive.
Because each application is unique, it is the responsibility of the purchaser, designer, installer and end user to ensure that
the total telephone entry/access control system is suitable for its intended use. Please consult the manuals and/or a qualified technician for further information.
NOTE:
If you have a multi unit configuration please see the EL Model installation guide.
Residence Phone Bypass Board
(Mount in the House)
Ring
Tip
OPERATE BYPASS
USE 18-24 AWG
2 twisted pair
Alarm System Position
(If applicable) Telco Entrance Box
Demarcation Point
USE 14 AWG
AC Power 12 VAC
polarity doesn’t matter
12 Gauge Minimum
IMPORTANT:
Run
ALL
wires through conduit hole.
The unit MUST be properly grounded!
Refer to local codes for grounding
recommendations.
DO NOT ground the unit to the
pedestal post if one is used.
Normally Open
Common
Use
18-24 AWG
Follow ALL local
electrical codes
SL3000UL™ CSW200UL™
SL585
SW490
Miracle-One™
Strike Input
or
(Exit Loop)
Strike Open
Basic Install
Complete
When Entry Code is keyed
into the EL Model, the gate
will open
For more information, refer to the Keypad Programming Manual
2 second setting recommended for gate relay.
24-Hour Time Relay No. Seconds From 3 to 9 Digits
Year Month Day Weekday
1 = Sunday
3 = Tuesday
5 = Thursday
0200 = 2AM
0800 = 8AM
2100 = 9PM
3 Short Beeps
Will be Heard
Factory Password Choose Entry Code
2005 January 1st 1:00PM
Saturday
Will be Heard
Audio Feedback
Will be Heard
Audio Feedback
Will be Heard
Audio Feedback
Will be Heard
Audio Feedback
Audio
Feedback
Will Be
Heard
Audio
Feedback
Will Be
Heard
Audio
Feedback
Will Be
Heard
Audio
Feedback
Will Be
Heard
If you make an error during an entry, press the asterisk key (*) to begin the sequence again.
1 long beep at the end of a sequence is an incorrect sequence, re-enter the correct sequence.
Enter Programming Mode Set the Clock Sequence Relay Time Sequence Enter Entry Code Sequence Exit Programming Mode
