Cisco TelePresence SX20N User manual

Cisco TelePresence SX20N Reference Guide
Ensure that the power cable is
plugged into the power outlet in the
wall.
Confirm that the network cable is
plugged into the network outlet in the
wall. The network cable must be
plugged into a dedicated OTN network
outlet.
Verify that the power bar is turned
on. The power bar supplies the whole
system and you can turn off your system
here at the end of your session.
Ensure that the monitor is on.
Check that the codec/camera is on
by checking the LED light at the front
of the codec
Pick up the remote control and
unmute your videoconferencing sound
by pressing the “Mic Off” button on the
remote control.
Turn the Self view on by navigating to
the camera icon using the remote
arrows and selecting the thumb tac icon.
TECHNICAL SUPPORT 1-866-454-6861
1
2
3
4
5
6
7

Cisco TelePresence SX20N Reference Guide
Zoom Camera in and out (Camera Mode)
Move Camera (Camera Mode)

Cisco TelePresence SX20N Reference Guide
Icons at the top right of the screen during a videoconference call
The camera icon enables you to turn self-view on (thumb tack),
turn self-view off (diagonal arrows) and preview camera view. In this
mode, use the arrows on the remote to move the camera and the
plus/minus to zoom in and out.
The layout icon allows you to choose where the picture-in-picture will be
situated on the screen. This icon only appears if the self-view has been
turned on.
The participant’s icon enables you to view the different systems that are in the
call. From here you can add favorites to the directory (star) and take
control of the far end camera (camera icon) .

Cisco TelePresence SX20N Reference Guide
Icons that appears when you press the enter button on the remote during a
videoconference.
The share icon enables you to present content from your computer with
others in the videoconference. Ensure you plug your presentation cable
into the back of the codec.
The add call icon adds other participant to the videoconference. This feature
is not supported by OTN. Adding other systems to an event can be done
using Ncompass (before the event) or calling OTN’s customer care team at
1.866.454.6861.
The pause icon is a privacy feature that enables you to put your system on
hold. When on hold, participants in the videoconference will not be able
to see and hear you.
The hang-up icon terminates the call.