Clarion CMM-20 User manual

CMM-20
Marine Source Unit with LCD Display
OWNER’S MANUAL
CMM20_MAN_ALL.indd 1 4/30/21 12:55 PM

2
FCC COMPLIANCE STATEMENT
This device complies with Part 15 of
the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful
interference, and (2) this device
must not accept any interference
received, including interference that
may cause undesired operation.
These limits are designed to provide
reasonable protection against
harmful interference in a residential
installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, the user is encouraged to
try to correct the interference by one
or more of the following measures:
- Reorient or relocate the
receiving antenna.
- Increase separation between the
equipment and the receiver.
- Connect the equipment to an
outlet on a circuit different
from that to which the receiver
is connected.
- Consult the dealer or an
experienced radio/TV technician
for help.
Any changes or modifications
not expressly approved by the
party responsible for compliance
could void the user’s authority
to operate this equipment.
SAFETY CONSIDERATIONS
• Only use this product in vehicles with
12 volt, negative-ground electrical
systems. This product is not certified
or approved for use in aircraft.
• Mount this product securely to
prevent damage or injury in
severe conditions.
• Do not replace the power wire fuse
with one of a different value.
Never bypass the fuse.
• Listen to your audio system at
levels appropriate for operating
conditions and hearing safety.
INSTALLATION CONSIDERATIONS
• Installation requires appropriate
tools and safety equipment.
Professional installation
is recommended.
• This product is water-resistant. Do
not submerge or subject to high-
pressure water spray.
• Before installation, turn off the audio
system and disconnect the battery
system from the audio system.
• Install in a dry, well-ventilated
location that does not interfere with
your factory-installed systems. If a
dry environment is not available,
a location that is not exposed to
heavy splashing may be used.
• Before cutting or drilling, check
for potential obstacles behind
mounting surfaces.
• Carefully route all system wiring
away moving parts and sharp
edges; secure with cable ties or
wire clamps and use grommets
and loom where appropriate to
protect from sharp edges.
CMM20_MAN_ALL.indd 2 4/30/21 12:55 PM

3
x1
#8 x 1 in (25 mm)
7/64 in
(2.78 mm)
x1 x1
x1 x1
#8 x 1 in (25 mm)
(x4)
3.68W in x 3.09H in
(94W mm x 79H mm)
GENERAL MOUNTING
CMM20_MAN_ALL.indd 3 4/30/21 12:55 PM

4
AUX
CMR-10
CMR-20
AM FM
USB
1A
USB
ANT
AUX-IN
REMOTE
Z1 SPKR OUT
Z2 SPKR OUT
Z1 L+ (WH)
Z1 L− (WH/BK)
Z1 R+ (GY)
Z1 R− (GY/BK)
Z2 L+ (GN)
Z2 L− (GN/BK)
Z2 R+ (VI)
ILLUMINATION (OR) +
GROUND (BK) −
AMP TURN-ON (BL) +
Z2 R− (VI/BK)
POWER
ZONE 2 / SUB
+12V
(10 - 14.4V DC)
15A
+12V DC (RD) +
GENERAL CONNECTIONS
CMM20_MAN_ALL.indd 4 4/30/21 12:55 PM

5
GENERAL CONTROL FUNCTIONS
Control Function
Volume/
Select
• Rotate to adjust volume
• Rotate/press for navigation and making selections
Source/
Power
• Short press to turn ON; Long press to turn OFF
• Short press to advance through available sources
Settings • Short press to access audio settings (Bass/Treble/Balance/Fader/EQ)
• Long press to access system settings (Z2-Sub/Beep/Area/Diagnostic)
Back/
Menu
• Short press to go back one step or access source specific menus
• Long press to advance through source specific menus
Favorites • Short press to access stored presets
• Long press to store a frequency as a preset (up to 9)
Mute/
Pause
• Short press to mute/unmute audio (AM/FM/WB/AUX) or
pause/resume the current selection (USB/Bluetooth)
Forward
Short press to:
• Manually adjust tuner forwards (AM/FM/WB)
• Select the next track (USB/Bluetooth)
Long press to:
• Seek to the next channel (AM/FM/WB)
• Fast-forward (USB/Bluetooth)
Backward
Short press to:
• Manually adjust tuner backwards (AM/FM/WB)
• Restart track/select the previous track (USB/Bluetooth)
Long press to:
• Seek to the previous channel (AM/FM/WB)
• Fast-rewind (USB/Bluetooth)
CMM20_MAN_ALL.indd 5 4/30/21 12:55 PM

6
FAVORITES MENU SETTINGS
• Short press to access settings/stored presets
• Long press to store a frequency as a preset (up to nine)
• Rotate to navigate
•Press to make selections
Setting Function
DELETE Select from stored presets for removal
REPLACE Permits replacement when all nine preset locations are occupied
SYSTEM MENU SETTINGS
• Long press to access settings
• Rotate to navigate
•Press to make selections
Setting Function
Z2/SUB Configures preamp outputs: Z2 (rear) or Subwoofer
BEEP Audible button press confirmation: On or Off
AREA Configures tuner region: USA, Europe, Australia or Other
DIAG Displays software version for diagnostics
AUDIO MENU SETTINGS
• Short press to access settings
• Rotate to navigate
•Press to make selections
Setting Function Note
BASS Bass level control from -10 to +10 EQ must be set to Off
TREBLE Treble level control from -10 to +10
BALANCE Balance control from full left (L10) to full right (R10)
FADER Fader control from full front (Z1:10) to full rear (Z2:10)
SUB Subwoofer preamp level control from 0 to +10 Z2/SUB must be set to SUB
EQ Select EQ presets: Off, Flat, Pop, Classic, Rock
CMM20_MAN_ALL.indd 6 4/30/21 12:55 PM

7
USB MENU SETTINGS
• Short press to access settings
• Rotate to navigate
•Press to make selections
Setting Function
RANDOM Random playback of all tracks within all folders: On or Off
REPEAT Repeats playback of the current track: On or Off
REPEAT FOLDER Repeats playback of all tracks within a folder: On or Off
PLAY ALL Plays all tracks within all folders: On or Off
FOLDERS LIST Displays folders within the USB
TRACKS LIST Displays tracks not located within a folder
AUX MENU SETTINGS
• Short press to access settings
• Rotate to navigate
•Press to make selections
Setting Function
SENS Configures AUX input sensitivity from -5 to +5
BLUETOOTH MENU SETTINGS
• Short press to access settings
• Rotate to navigate
•Press to make selections
Setting Function
PAIR NEW
DEVICE Initiates Pairing Mode (current connected devices will be disconnected)
CONNECT
PAIRED DEVICE Display all paired devices for connection
SET PRIMARY
DEVICE Assign priority to a paired device for automatic connection
DELETE PAIRED
DEVICE Select from paired devices for removal
DELETE ALL
DEVICES Removes all paired devices from memory
CMM20_MAN_ALL.indd 7 4/30/21 12:55 PM

8
SPECIFICATIONS
Electrical
Operating Voltage 14.4V DC (10V – 16V)
Operating Temp Range -22 F to +167 F (-30 C to +75 C)
Current Draw / Fuse Value 15 A (max) / 33 mA (standby) / 15 A
Remote Turn-On Output 500 mA
Display 2.37 in. TFT LCD backlit
Tuner
FM Tuner
USA: 87.9 MHz to 107.9 MHz (0.2 MHz step)
EUR: 87.50 MHz to 108.00 MHz (0.05 MHz step)
AUS: 87.50 MHz to 108.00 MHz (0.10 MHz step)
OTHER: 87.50 MHz to 108.00 MHz (0.05 MHz step)
AM Tuner
USA: 530 kHz to 1710 kHz (10 kHz step)
EUR: 531 kHz to 1602 kHz (9 kHz step)
AUS: 531 kHz to 1629 kHz (9 kHz step)
OTHER: 531 kHz to 1629 kHz (9 kHz step)
NOAA Weatherband USA: 162.400 MHz - 162.550 MHz (0.025 MHz step)
Favorites 9 presets across all bands
Bluetooth®
Profile 5.0
Core Specification / Codec Version 2.1 + EDR / SBC
Connection Range Up to 35 ft / 11 m
USB
Interface USB 2.0 HIgh Speed
Supported Audio Formats MP3, WMA, FLAC, WAV
File Limits
Folders: 255
Files in a single folder: 3,000
Total Files: 9,999
Charging Output 1 A
Preamp Audio Outputs/Inputs
Output Channels One stereo pair of RCA plugs (1.5V RMS)
Output Configuration Selectable: Zone 2 or Subwoofer
Auxiliary Input Channels One stereo pair of RCA plugs (2V RMS Max)
Amplified Audio Outputs
Rated RMS Power @ 14.4V 25W x 4 @ 4 Ω
Audio Control Options
Tone & Balance Bass, Treble, Balance, Fader (Zone 1 / Zone 2 or Subwoofer)
EQ Selectable: Off, Flat, Pop, Classic, Rock
Dimensions
Unit W x H x D 5.95 in. x 3.90 in. x 3.15 in. (151 mm x 99 mm x 80 mm)
Mounting Hole W x H 3.68 in. x 3.09 in. (94 mm x 79 mm)
CMM20_MAN_ALL.indd 8 4/30/21 12:55 PM

9
CMM20-MAN 041221
OPTIONAL REMOTE CONTROLLERS
Add control capabilities from auxiliary
locations with optional wired remotes
(sold separately). Connect up to three
controllers to a single source unit,
at up to 75 ft (23m) away (cumulative
cable length). Each wired remote
connects directly using controller
cables and 2-way splitters (sold
separately). Refer to the supplied
Owner’s Manual for specific user and
installation instructions.
CMR-10
Wired Remote Controller
Auxiliary, water-resistant
(IP67 rated) controller
CMR-20
Wired Remote Controller
with LCD Display
Full-function, water-resistant
(IP67 rated) controller
CMM20_MAN_ALL.indd 9 4/30/21 12:55 PM

©2021 Clarion Marine Audio
Printed in China
CMM20_MAN_ALL.indd 52 4/30/21 12:56 PM