Comeup GTD-650 User manual

Heavy Duty Hoist
Model:
GTD
-
65
0
PN: 750265 12V
750280 24V
Introduction
Feature
Line lifting: 295 kg / 650 lb wire rope first layer
Wire rope: 3.6 mm × 18.3m galvanized aircraft A7 × 19
Brake:
Mechanical spring applied and permanent motor
dynamic brakes together
Control: Handheld pendant switch powers the hoist
Unpacking
．
．．
． Hoist assembly…………………………………………………………… 1 pc
．
．．
． Control box………………………………………................................... 1 pc
．
．．
． Remote control……………………………………………………………
1 pc
．
．．
． Wire rope with hook………………………………………………………
1 pc
Read this manual carefully
Carefully read and understand this manual before operating the winch.
Careless winch operation may result in personal injury, danger to others and or
damage to property
Information requesting or parts ordering
Please specify the following information:
．
．．
．
Hoist PN
．
．．
．
Part description
．
．．
．
Serial number
．
．．
．
Replacement part number
．
．．
．
Quantity for each part

Installation
Before using the winch ensure all electrical components are in good condition
and all connections are sound.
Hoist mounting
．
．．
．
Four (4) M8 x 25L 8.8 grade with 22 N-m torque settings (maximum) high
tensile steel bolts must be used in order to sustain the loads imposed on the
winch mounting
Wire Rope Replacement
．
．．
． Feed the end of the wire rope through the anchor hole in the drum and make
a loop in the anchor pocket. Insert a wedge in the loop and tighten the rope
for securing purpose.
．
．．
． Make sure the first layer of wire rope is tight and maintain a freeboard at least
1.5 x rope diameter.
．
．．
．
Wire rope shall be wound in an under-wound orientation only.

Wiring Diagram
Attach the black lead firmly to the negative (–)battery terminal and red lead to
the positive (+) battery terminal. The voltage drop for the winch motor must not
exceed 10% of the nominal voltage of 12/24vdc.
Warning
． The operator shall always work in compliance with the operating instructions.
． Do not Overload the winch. Overload protection should be provided.
． Not for the Transporting or lifting of personnel.
． Excessive inching should be avoided
． Don’t try to move obstructed loads and side-pull of load is not allowed
． A minimum of 5 compete wraps of rope on the drum is required at all times

Parts List
Item No. Description Part No. Qty
1 Motor 12V 882417 1
Motor 24V 882288
2 Motor couple kit 880988 1
3 Drum bushing 880990 2
4 Drum kit 882322 1
5 Tie bar kit 880992 1
6 Tie bar kit 880993 2
7 Gearbox support rack 880994 1
8 3
rd
stage carrier 880995 1
9 2
nd
stage carrier 880996 1
10 1
st
stage carrier 880997 1
11 2
nd
ring gear kit 880998 1
12 1
st
shaft kit 880999 1
13 Gearbox kit 882418 1
14 Gearbox rear cover kit 882320 1
15 Remote control 880025 1
16 Control box 12V 882313 1
Control box 24V 882314
16-1 Remote socket kit 880029 1
16-2 Control pack 12V 882315 1
Control pack 24V 882316
17 Mounting hardware 882545 1
18 Wire rope w/hook 882323 1

Hoist Assembly (GTD650)