Comeup WK-100L User manual

1
WK-100L
INSTALLATION INSTRUCTION
AC110V PN:884018
A
C220V PN:884019
A
C240V PN:884020
Wi
r
eless Control Kit For COMEUP CWL-200/200L/301/301L Winch
Includes:
1.Wireless Receiver 2.Wireless Transmitter.883844 3.Power cord receptacle.884021
Specifications:
Control module Indirect control +Wireless Control
Frequency band 433MHz
Typical operating range 100 M (328 ft)
Applicable current AC 110V 15A / 220V 7.5A / 240V 7.5A
Function Go up / Go down / Emergency stop
Control Unit
Power Input Current range 110V OR 220V OR 240V
Power cord for main power source 2.0 mm × 3C ×1.5M
Power Output Power cord for winch 2.0 mm × 3C/3P quick connector
Control cord 2.0 mm × 6C/6P quick connector
contactors Number 3 sets
Receiver Power supply AC 110V / 220V / 240V
Function Go up / Go down / built-in buzzer
Protection degree IP67
Transmitter
Power supply DC3V
Button Emergency stop switch, Power on switch
Power consumption 16mA
Battery LR6(AA)1.5V*2
Protection degree IP65
Environment
Operating temperature -25°C ~ + 55°C
Storage temperature -40°C ~ + 65°C
Humidity 90%RH
Complied with RED directive 2014/53/EU
2
Installation Guide:
1.Change power lead
a. Use a Philip screw driver to remove 3 wirings on the control panel accordingly.
b. Use a Philip screw driver to fasten all the 3 wirings of power cord receptacle (NO.3)
accordingly with 1. Green wire (Ground wire), 2.Black wire and 3.White wire.
2.Wiring

3
Operation:
1. Install and replace battery
Remove 3 battery cap and replace batteries (1.5V,LR6AA×2) into transmitter.
2. Start
a. Turn to release the 1 emergency button.
b. Press 2 Start button.
※ The Start/Horn switch has 2 modes:
(1). Press to start.
(2). Press for alarm before each operation.
3. Stop
a. Turn the transmitter off by completely pressing the 1 emergency button
b. The transmitter turns off. All relays deactivate.
4
4.Troubleshooting
Transmitter
Receiver
Should an error occur, LED of the receiver unit will indicate the cause of the error.
2021/01/13 Ver:0