Comeup WK-100H User manual

1
WK-100H
INSTALLATION INSTRUCTION
AC110V PN:883874
AC220V PN:883875
AC240V PN:883881
Wireless Control Kit For COMEUP CSH Winch
Includes:
1.Wireless Receiver
2.Wireless Transmitter.883844
Specifications:
Control module Indirect control +Wireless Control
Frequency band 433MHz
Typical operating range 100 M (328 ft)
Applicable current AC 110V 15A / 220V 7.5A / 240V 7.5A
Function Go up / Go down / Emergency stop
Control Unit
Power Input Current range 110V OR 220V OR 240V
Power lead for main power source 2.0 mm × 3C/3P quick connector
Power Output Power lead for winch 2.0 mm × 3C/3P quick connector
Control lead 2.0 mm × 6C/6P quick connector
contactors Number 3 sets
Receiver Power supply AC 110V / 220V / 240V
Function Go up / Go down / built-in buzzer
Protection degree IP67
Transmitter
Power supply DC3V
Button Emergency stop switch, Power on switch
Power consumption 16mA
Battery LR6(AA)1.5V*2
Protection degree IP65
Environment
Operating temperature -25°C ~ + 55°C
Storage temperature -40°C ~ + 65°C
Humidity 90%RH
Complied with RED directive 2014/53/EU
2
Installation Guide:
1. Assemble the bracket and wireless control kit with M5x12L screw.
2. Disassemble the A and B nut (M10) on CSH winch.
3. Assemble the wireless control kit and CSH winch. (wireless remote bracket passing
through the screw, then fasten with A and B nut.)

3
Operation:
1. Install and replace battery
Remove 3 battery cap and replace batteries (1.5V,LR6 AA×2) into transmitter.
2. Start
a. Turn to release the 1 emergency button.
b. Press 2 Start button.
※ The Start/Horn switch has 2 modes:
(1). Press to start.
(2). Press for alarm before each operation.
3. Stop
a. Turn the transmitter off by completely pressing the 1 emergency button
b. The transmitter turns off. All relays deactivate.
4
4.Troubleshooting
Transmitter
Receiver
Should an error occur, LED of the receiver unit will indicate the cause of the error.
2020/07/20 Ver:1