Cree LS8 User manual

LS Series
Reflector
Includes: LS4 and LS8 luminaires
INSTALLATION INSTRUCTIONS
1 of 2 LPN00278X0001A0_B
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant
l’installation.
2. This luminaire must be installed in accordance with the NEC or
your local electrical code. If you are not familiar with these codes
and requirements, consult a qualied electrician.
Ce produit doit être installé conformément à NEC ou votre code
électrique local. Si vous n’êtes pas familier avec ces codes et
ces exigences, veuillez contacter un électricien qualié.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
TO INSTALL:
INSTALLATION
NOTE: 4-foot and 8-foot reflectors are
available for LS4 and LS8 luminaires
respectively. Images in the figures
depict LS4 with reflectors containing
apertures for illustration purposes.
The reflectors may or may not contain
apertures.
STEP 1:
Align the reflector to the luminaire as
shown in Figure 1.
STEP 2:
Mount the reflector to the luminaire
using one of the following methods:
Surface Mounting
Use (2) #6-20 Self Drilling Screws
provided with the reflector to attach
the reflector from the side as shown
in Figure 2. For LS8 luminaires attach
(4) screws as shown in Figure 3.
Suspended Mounting
Reflector can be attached from the
side as shown in Figure 2 and 3 or
from the top as shown in Figure 4
for LS4 and Figure 5 for LS8.Use
supplied #6-20 Self Drilling Screws.
1Reflector
2
Reflector
#6-20 Self
Drilling Screws
3
Reflector
#6-20 Self
Drilling Screws

2 of 2 LPN00278X0001A0_B
www.cree.com/lighting
© 2014 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See www.cree.com/lighting for warranty and specifications. Cree® and the Cree logo are registered
trademarks.
STEP 3:
Repeat Step 1 and 2 above to
attach the reflector onto the other
side of the luminaire.
STEP 4:
Refer to LS installation sheet,
provided with luminaire, to
complete installation of luminaire
and electrical connections.
4
5
Reflector
#6-20 Self
Drilling Screws
Reflector