Cree CR Series User manual

1 of 2 LPN00470X0001A0_A
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
CR Series
LED Luminaire With Emergency Driver
Includes: EB14 Driver Replacement
TO INSTALL:
STEP 1:
Remove screw from battery compartment. See Figure 1.
STEP 2:
Remove cover from battery compartment. See Figure 2.
STEP 3:
Disconnect connector by depressing latch. See Figure 3.
STEP 4:
Remove existing battery and properly dispose of the battery per local
codes. See Figure 4.
12
3
IMPORTANT SAFETY INFORMATION
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
2. This luminaire must be installed in accordance with the NEC or your local electrical code. If you are not familiar with these codes
and requirements, consult a qualied electrician.
Ce produit doit être installé conformément à NEC ou votre code électrique local. Si vous n’êtes pas familier avec ces codes et
ces exigences, veuillez contacter un électricien qualié.
3. Access above ceiling required.
Accès requis au-dessus du plafond.
4. Do not handle energized module with wet hands or when standing on wet or damp surfaces, or in water.
5. Do not use this equipment for other than its intended use.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE
4

2 of 2 LPN00470X0001A0_A
lighting.cree.com
© 2016 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See http://lighting.cree.com/warranty for warranty and specifications. Cree® is a registered trademark, and the Cree logo is a
trademark of Cree, Inc.
STEP 5:
Replace with new battery and push connector into place
until latched. See Figure 5.
STEP 6:
Replace cover and screw that was previously removed.
See Figure 6.
5
6